(use)the premises for single family dwelling

Upgrade service from 1 amp to 1 amp install new circuits install low voltage as per code.

Install complete ductwork throughout house with a 75 0 btu 90% gas furnace and a 3-ton a/c unit as per code. Gas & electric by others

(11) new plumbing fixtures. Gas to furnace 70k range 48k. Electric water heater and reconstruct water and waste as per code. Hvac by others

Non-structural alterations/exterior work - remove formstone clean cut and point front of house as per code. Separate permit required from dgs

"noncomplying row house addition interior work (1515 sq ft)/exterior work - addition - structural alterations - category ii - new interior framing (2x4 at 16"" oc) and drywall new interior stairs and hangars new rear sidings and new rubber roof over exist"

Structural alterations/interior work 5 sq. Ft. - the work description on the application should include the following: underpinning of foundation walls as per attached engineers plans and certification. The engineer certification is required at complet

Noncomplying row house addition interior work (1515 sq ft)/exterior work - addition - structural alterations - category ii - new interior framing (2x4 at 16" oc) and drywall new interior stairs and hangars new rear sidings and new rubber roof over existing roof. New floor finishing new trim nre interior doors (10) new exterior doors (3) new windows (8) and new paint. Existing windows and doors same size and locations. New insulation (r-21 for walls and r49 for roof) no slab removal. New exterior siding removal of plaster drywall windows doors trims non-bearing walls roofing & flooring materials and removal of debris and equipment. New first floor addition (13-6"x4-6") new second floor addition (13-6"x9-6") and a roof top deck (24-0"x12-6") as per sketch & as per code. Mech elect and plumbing permits to obtain separately

Structural alterations/interior work 5 sq. Ft. - the work description on the application should include the following: underpinning of foundation walls as per attached engineers plans and certification. The engineer certification is required at completion of work and with a report of the exact dates of periodic inspections during the construction (12-10" x 40-8") 5 sq. Ft. Existing ceiling height = 6-0" proposed ceiling height = 8-0" as per sketch as per code.

Noncomplying row house addition interior work (1515 sq ft) exterior work - addition - structural alterations - category ii - new interior framing (2x4 at 16" oc) and drywall new interior stairs and hangars new rear sidings and new rubber roof over existing roof. New floor finishing new trim nre interior doors (10) new exterior doors (3) new windows (8) and new paint. Existing windows and doors same size and locations. New insulation (r-21 for walls and r49 for roof) no slab removal. New exterior siding removal of plaster drywall windows doors trims non-bearing walls roofing & flooring materials and removal of debris and equipment. New first floor addition (13-6"x4-6") new second floor addition (13-6"x9-6") and a roof top deck (24-0"x12-6") as per sketch & as per code. Mech elect and plumbing permits to obtain separately

Structural alterations interior work 5 sq. Ft. - the work description on the application should include the following: underpinning of foundation walls as per attached engineers plans and certification. The engineer certification is required at completion of work and with a report of the exact dates of periodic inspections during the construction (12-10" x 40-8") 5 sq. Ft. Existing ceiling height = 6-0" proposed ceiling height = 8-0" as per sketch as per code.

Non-structural alterations exterior work - remove formstone clean cut and point front of house as per code. Separate permit required from dgs

Install complete ductwork throughout house with a 75 0 btu 90% gas furnace and a 3-ton a c unit as per code. Gas & electric by others