Installation of complete ductwork with a 75 0 btu 90% gas furnace 3 ton coil and a/c unit. Gas and electric by others. Work done to code.

Upgrade service to 1 amp install new ckts install 6 low voltage as per code.

Exterior work: remove formstone clean cut & point brick on front of house. As per code.

Category ii - structural alterations - interior work 1688 s q. Ft -1 storyaddition-- 1419 cubic ft remove existing non-structural rear wall to access new addition. ===non-structural demo and removal of plaster drywall windows doors non-bearing wall

Install 11 new plumbing fixtures gas to 70k and range 50k electric hot water heater reconstruct water and waste. All work done to code.

Structural alterations/interior work 473 sq ft - underpinning of foundation walls as per attached engineers plans and certification. The engineer certification is required at completion of work and with a report of the exact dates of periodic inspections

Category ii - structural alterations - interior work 1688 s q. Ft -1 storyaddition-- 1419 cubic ft remove existing non-structural rear wall to access new addition. ===non-structural demo and removal of plaster drywall windows doors non-bearing wall roofing and floor material and removal of debris and equipment new 1st & 2nd floor addition (3x22-0) new roof deck (134"x16-0") new interioir framing and drywall and drywall (2x4 studs @16" o. C for 1st and 2nd floor. New 3-0" wide stairs (7. 75" max risers 10" treads) and hangers. New floors finishing new interior doors (12) new exterior doors (1) new windows (5) new sidings and new rubber roof replace. Existing windows (5)and doors(2) same size and locations. New insulation (r-21 for walls and r49 for roof - replace slab in basement with 4" concrete slab and gravel - separate permit required for mechancial electical and plumbing permits as per code as per drawing/code

Structural alterations/interior work 473 sq ft - underpinning of foundation walls as per attached engineers plans and certification. The engineer certification is required at completion of work and with a report of the exact dates of periodic inspections during the contruction. Existing basement heght = 6-0" proposed height = 8-0"as per drawings. As per code.

Category ii - structural alterations - interior work 1688 s q. Ft -1 storyaddition-- 1419 cubic ft remove existing non-structural rear wall to access new addition. ===non-structural demo and removal of plaster drywall windows doors non-bearing wall roofing and floor material and removal of debris and equipment new 1st & 2nd floor addition (3x22-0) new roof deck (134"x16-0") new interioir framing and drywall and drywall (2x4 studs @16" o. C for 1st and 2nd floor. New 3-0" wide stairs (7. 75" max risers 10" treads) and hangers. New floors finishing new interior doors (12) new exterior doors (1) new windows (5) new sidings and new rubber roof replace. Existing windows (5)and doors(2) same size and locations. New insulation (r-21 for walls and r49 for roof - replace slab in basement with 4" concrete slab and gravel - separate permit required for mechancial electical and plumbing permits as per code as per drawing code

Structural alterations interior work 473 sq ft - underpinning of foundation walls as per attached engineers plans and certification. The engineer certification is required at completion of work and with a report of the exact dates of periodic inspections during the contruction. Existing basement heght = 6-0" proposed height = 8-0"as per drawings. As per code.

Installation of complete ductwork with a 75 0 btu 90% gas furnace 3 ton coil and a c unit. Gas and electric by others. Work done to code.