Get several free quotes from best contractors in your area.
| Content | Date | Cost | Contractor Rank | Address | Contractor |
|---|---|---|---|---|---|
Add (3) antennas swap (1) amp breaker for (1) amp breaker as per plans as per code. If installing suppression system in equipment cabinet then a separate permit is required. Permit id: Com2014-19147 | |||||
Swap 9 antennas install 3 rrhs on existing tower as per plans and as per code. If installing suppression system in equipment cabinet then separate permit is required. Permit id: Com2014-32556 | |||||
Remove and replace 6 antennas with alternative models as per plans and as per code. If installing suppression system in equipment cabinet then a separate permit will be required. Permit id: Com2013-20675 | |||||
Original permit description:(com2012-09588)exterior work - non-structural alterations - remove and replace existing antennas on existing structure. Antenna will be located at same rad center as existing. Keep equipment cabinet at existing location as per Permit id: Com2013-10455 | |||||
Original permit description:(com2010-27959)fire alarm system replacement as per plan as per code. Permit id: Com2012-19683 | |||||
Installation of three antennas on the existing self-support/lattice tower;and the placement of a 4x4 platform along with equipment cabinets and associated lines for the antennas power and telco. As per plan and as per code. As per bmz2012-00177 approv Permit id: Com2012-12227 | |||||
Exterior work - non-structural alterations - remove and replace existing antennas on existing structure. Antenna will be located at same rad center as existing. Keep equipment cabinet at existing location as per plans as per code Permit id: Com2012-09588 | |||||
Fire alarm system replacement as per plan as per code. Permit id: Com2010-27959 | |||||
Remove and replace 12 antennas on existing monopole. Eight antennas will be moved to a new height on the existing monopole. No ground work will be performed. No electrical work being done if installing suppression system in equipment cabinet then a se Permit id: Com2010-14294 | |||||
Adding (1) amp ckt as per code. Permit id: Com2010-18788 | |||||
Restoration work on an interior swimming pool. Install with new a recirculatory gutter system and new anti-entrapment dual drains; install new handrails for a total of 6 pairs as per plans as per code. Permit id: Com2010-07664 | |||||
Upgrade existing 2 amp service to 4 amp as per code Permit id: Com2010-04232 | |||||
At&t proposes to install (3) additional antennas at this existing telecommunications site as per plans as per code. If installing suppression system in equipment cabinet then a separate permit will be required. Permit id: Com2010-06679 | |||||
Installing (1) 2 amp feeder with (40) 15 amp circuits. Replace existing kva ups with new kva ups as per code Permit id: Com2010-02593 | |||||
Install one transport dish on an existing tower mount and run a 3/8 diameter coax cable from dish to existing equipment per bmza 137-08 as per plans as per code. If installing suppression system in equipment cabinet(s) then a separate permit is required Permit id: Com2009-04292 | |||||
Temporary service install 2 amp service and (1) circuit. As per code. Permit id: Com2008-29456 | |||||
Amend permit#com2008-06633 issued on 4-9-08 to add contractors aslisted above. Original permit description:(com2008-06633)co-locating 6 antennas to existing tower with a x 14 concrete pad with one radio cabinet and placed on pad as per plans asper code. Permit id: Com2008-18055 | |||||
Co-locating 6 antennas to existing tower with a x 14 concrete pad with one radio cabinet and placed on pad as per plans asper code. Per bmza 137-08 Permit id: Com2008-06633 | |||||
Install (1) one new equipment cabinet in the existing compound and (1) one dish antenna mounted to the existing lattice tower as per plans as per code. Permit id: Com2007-11547 | |||||
Reinstate permit #com2005-12119 for thirty (30) days for final inspectionoriginal permit description:(com2005-12119)replace exist antennas on existing tower and install one equipment cabinets inside of exist unmanned equipment shelter Permit id: Com2006-39501 | |||||
Reinstate permit # com2005-12119 for thirty (30) days for final inspection. Original permit description:(com2005-12119)replace exist antennas on existing tower and install one equipment cabinets inside of exist unmanned equipment shelter Permit id: Com2006-38317 | |||||
Install single face int-illuminated free-standing one scoreboard 8 x 18=144 sq. Ft. High. Electric by others. Located on athletic field.(located on athletic field) Permit id: Com2005-29403 | |||||
Amend permit # com2005-12119 issued on 5/24/05 w/ plan # 564 to add low voltage contractor as listed Permit id: Com2005-25890 | |||||
Replace exist antennas on existing tower and install one equipment cabinets inside of exist unmanned equipment shelter Permit id: Com2005-12119 | |||||
Amend permit # com2004-20735 issued 9/28/04 with plan # 2004-1056 to name electrical contractor name as above Permit id: Com2004-28257 | |||||
Permit id: Com2004-28258 | |||||
Construct 25 long retaining wall that will connetct to existing wall approx 5 hight as per attached sketches Permit id: Com2004-28259 | |||||
"install 12 antennas on existing tower; install an unmanned equipment shelter 116""x as per plans." Permit id: Com2004-20735 | |||||
Install wet chemical fire suppression system in kitchen hood Permit id: Com2004-23870 | |||||
Amend permit#com2004-192 issued on 8-26-04 w/plans#2004-988 to name prime contractor as stated above. Permit id: Com2004-22332 | |||||
Amend permit # 1849 to add prime contractor and electrical comtractor Permit id: Com2002-07892 | |||||
Remove and replace 12 antennas on existing monopole. Eight antennas will be moved to a new height on the existing monopole. No ground work will be performed. No electrical work being done if installing suppression system in equipment cabinet then a separate permit will be required. Expiration date: June 15, 2011 | Permit id: Com2010-14294 | |||||
Install one transport dish on an existing tower mount and run a 3/8 diameter coax cable from dish to existing equipment per bmza 137-08 as per plans as per code. If installing suppression system in equipment cabinet(s) then a separate permit is required. Expiration date: September 26, 2009 | Permit id: Com2009-04292 | |||||
Amend permit#com2008-06633 issued on 4-9-08 to add contractors aslisted above. Original permit description:(com2008-06633)co-locating 6 antennas to existing tower with a x 14 concrete pad with one radio cabinet and placed on pad as per plans asper code. Per bmza 137-08 Expiration date: April 9, 2009 | Permit id: Com2008-18055 | |||||
Installation of three antennas on the existing self-support/lattice tower;and the placement of a 4x4 platform along with equipment cabinets and associated lines for the antennas power and telco. As per plan and as per code. As per bmz2012-00177 approved on5/30/12: if installing suppression system in equipment cabinet then a separate permit is required. Expiration date: July 26, 2013 | Permit id: Com2012-12227 | |||||
Original permit description:(com2012-09588)exterior work - non-structural alterations - remove and replace existing antennas on existing structure. Antenna will be located at same rad center as existing. Keep equipment cabinet at existing location as per plans as per code Expiration date: December 6, 2013 | Permit id: Com2013-10455 | |||||
Install 12 antennas on existing tower; install an unmanned equipment shelter 116"x as per plans. Expiration date: September 28, 2005 | Permit id: Com2004-20735 | |||||
Remove 6 antennas and add 12 new antennas on existing tower. Expiration date: February 26, 2005 | Permit id: Com2004-19260 | |||||
Install foundation and kw generatorinstall 4 amp automatic transfer switchinstall 2- amp circuits. One for heater jacket and one for battery charger. Expiration date: February 24, 2005 | Permit id: Com2004-19172 | |||||
Replacing 3 antennas with 3 new antennas as per plans as per code. Expiration date: October 29, 2016 | Permit id: Com2016-01459 | |||||
Remove and replace 3 panel antennas at their existing antenna installation as per plans as per code. If installing suppression system in equipment cabinet then separate permit is required. Expiration date: March 8, 2017 | Permit id: Com2016-20354 | |||||
Installing one generator and 1 gallon propane tank within the existing compound as per plans as per code. Expiration date: August 7, 2017 | Permit id: Com2016-27178 | |||||
Install one transport dish on an existing tower mount and run a 3 8 diameter coax cable from dish to existing equipment per bmza 137-08 as per plans as per code. If installing suppression system in equipment cabinet(s) then a separate permit is required. Expiration date: September 26, 2009 | Permit id: Com2009-04292 | |||||
Amend permit # com2004-20735 issued 9 28 04 with plan # 2004-1056 to name electrical contractor name as above Expiration date: September 28, 2005 | Permit id: Com2004-28257 | |||||
Amend permit # com2005-12119 issued on 5 24 05 w plan # 564 to add low voltage contractor as listed Expiration date: May 24, 2006 | Permit id: Com2005-25890 | |||||
Installation of three antennas on the existing self-support lattice tower;and the placement of a 4x4 platform along with equipment cabinets and associated lines for the antennas power and telco. As per plan and as per code. As per bmz2012-00177 approved on5 30 12: if installing suppression system in equipment cabinet then a separate permit is required. Expiration date: July 26, 2013 | Permit id: Com2012-12227 | |||||
Amend permit#com2004-192 issued on 8-26-04 w plans#2004-988 to name prime contractor as stated above. Expiration date: February 26, 2005 | Permit id: Com2004-22332 |