Continue to use premises as a garage for storage repair and servicing of motor vehicles-including body and fender repair

"non-structural alterations/interior work 6 sq. Ft. Removal of interior non-structural petition. Exterior work - remove cement block from entrance bay #4; install overhead garage door 10x10; remove cement block at entrance door and replace 32"" steel do"

Install 3 new remote radio heads on an existing cell tower. (no ground work) as per plans and as per code. If installing suppression system in equipment cabinet then a separate permit is required.

"repair storm damage to existing billboard electrical system. Replace 1"" rmc service entrance raceway & #6 thhn conductors. Replace 3/4"" rmc branch circuits raceway & #12 thhn conductors . Amp service panel & meter socket as per code."

Remove and replace (6) existing antennas with (6) new antennas. As per plans as per code. If installing suppression system in equipment cabinet then a separate permit is required.

Install (3) antennas at existing telecommunicatuions site as per plans as per code. If installing suppression system in equipment cabinets then a separate permit is required.

(use) use portion of premises as an antenna for cell phone communication.

Amend permit#com2009-06057 issued on 3/27/09 with plans #2009-3 to add contractor as listedoriginal permit description:(com2009-06057)amend permit # com2008-33329 issued on 1/13/09 with plans # 2008-1725 to add the following additional work extensio

Amend permit com2009-06057 issued on 03/27/09 with plans #2009-3 to add electrical contractor as listed above. Original permit description:(com2009-06057)amend permit # com2008-33329 issued on 1/13/09 with plans # 2008-1725 to add the following additio

Amend permit # com2008-33329 issued on 1/13/09 with plans # 2008-1725 to add the following additional work extension pole on the existing monopole per bmza 706-08 approved 11/14/08 as per plans as per code. Original permit description:(com2008-33329)p

Amend permit #com2008-28182 issued on 11/24/08 with plans #2008-1451 to add electrical contractor(s) as listed above. Original permit description:(com2008-28182)extend existing ft monopole ft to new 1 ft height install six panel antennas construc

Proposed unmanned equipment shelter and standby generator on grade with (12) antennas mounted on existing monopole tower as per plans as per code. If installing suppression system in equipment cabinet(s) then a separate permit is required.

Extend existing ft monopole ft to new 1 ft height install six panel antennas construct 1ft x 11ft concrete pad within existing compound place equipment cabinets on pad per bmza 706-08 approved 10/14/08 as per plans and code

Amend permit com2009-06057 issued on 03/27/09 with plans #2009-3 to add electrical contractor as listed above. Original permit description:(com2009-06057)amend permit # com2008-33329 issued on 1/13/09 with plans # 2008-1725 to add the following additional work extension pole on the existing monopole per bmza 706-08 approved 11/14/08 as per plans as per code. Original permit description:(com2008-33329)proposed unmanned equipment shelter and standby generator on grade with (12) antennas mounted on existing monopole tower as per plans as per code. If installing suppression system in equipment cabinet(s) then a separate permit is required.

Amend permit #com2008-28182 issued on 11/24/08 with plans #2008-1451 to add electrical contractor(s) as listed above. Original permit description:(com2008-28182)extend existing ft monopole ft to new 1 ft height install six panel antennas construct 1ft x 11ft concrete pad within existing compound place equipment cabinets on pad per bmza 706-08 approved 10/14/08 as per plans and code

Amend permit#com2009-06057 issued on 3/27/09 with plans #2009-3 to add contractor as listedoriginal permit description:(com2009-06057)amend permit # com2008-33329 issued on 1/13/09 with plans # 2008-1725 to add the following additional work extension pole on the existing monopole per bmza 706-08 approved 11/14/08 as per plans as per code. Original permit description:(com2008-33329)proposed unmanned equipment shelter and standby generator on grade with (12) antennas mounted on existing monopole tower as per plans as per code. If installing suppression system in equipment cabinet(s) then a separate permit is required.

Amend permit # com2008-33329 issued on 1/13/09 with plans # 2008-1725 to add the following additional work extension pole on the existing monopole per bmza 706-08 approved 11/14/08 as per plans as per code. Original permit description:(com2008-33329)proposed unmanned equipment shelter and standby generator on grade with (12) antennas mounted on existing monopole tower as per plans as per code. If installing suppression system in equipment cabinet(s) then a separate permit is required.

Repair storm damage to existing billboard electrical system. Replace 1" rmc service entrance raceway & #6 thhn conductors. Replace 3/4" rmc branch circuits raceway & #12 thhn conductors . Amp service panel & meter socket as per code.

Non-structural alterations/interior work 6 sq. Ft. Removal of interior non-structural petition. Exterior work - remove cement block from entrance bay #4; install overhead garage door 10x10; remove cement block at entrance door and replace 32" steel door (same size and location) as per code.

(use) continue to use premises as a garage for the storage servicing and repair of motor vehicles-including tires body and fender. Outdoor storage of parts and junked vehicles is prohibited.

The property is currently used for an auto mobile repair garage. Applicant proposes to build an ft high steel monopole up to nine panels antennas would be placed on the pole. A foot by foot concrete pad would be constructed at the base of the pole. Up to 3 cabinets would be installed on the pad. The installation would be surrounded by a chain link fence.

Amend building permit com2002-15851 to add t&b electric as the electrical contractor

Tmemporary construction permit for service2 amp120/240

(use) use entire premises as garage for storage repair and servicing of motor vehicles under one & one-half tons but not including body work painting or engine rebuilding per b. M. Z. A. 353-97x

Original permit description:(com2015-13572)non-structural alterations/interior work 6 sq. Ft. Removal of interior non-structural petition. Exterior work - remove cement block from entrance bay #4; install overhead garage door 10x10; remove cement block at entrance door and replace 32" steel door (same size and location) as per code.

Replace 3 existing air21 antennas with 3 new air32 antennas as per plans as per code. If installing suppression system in equipment cabinet then separate permit is required.

Original permit description:(com2015-13572)non-structural alterations interior work 6 sq. Ft. Removal of interior non-structural petition. Exterior work - remove cement block from entrance bay #4; install overhead garage door 10x10; remove cement block at entrance door and replace 32" steel door (same size and location) as per code.

Non-structural alterations interior work 6 sq. Ft. Removal of interior non-structural petition. Exterior work - remove cement block from entrance bay #4; install overhead garage door 10x10; remove cement block at entrance door and replace 32" steel door (same size and location) as per code.

Extend existing ft monopole ft to new 1 ft height install six panel antennas construct 1ft x 11ft concrete pad within existing compound place equipment cabinets on pad per bmza 706-08 approved 10 14 08 as per plans and code

Amend permit #com2008-28182 issued on 11 24 08 with plans #2008-1451 to add electrical contractor(s) as listed above. Original permit description:(com2008-28182)extend existing ft monopole ft to new 1 ft height install six panel antennas construct 1ft x 11ft concrete pad within existing compound place equipment cabinets on pad per bmza 706-08 approved 10 14 08 as per plans and code

Amend permit # com2008-33329 issued on 1 13 09 with plans # 2008-1725 to add the following additional work extension pole on the existing monopole per bmza 706-08 approved 11 14 08 as per plans as per code. Original permit description:(com2008-33329)proposed unmanned equipment shelter and standby generator on grade with (12) antennas mounted on existing monopole tower as per plans as per code. If installing suppression system in equipment cabinet(s) then a separate permit is required.

Repair storm damage to existing billboard electrical system. Replace 1" rmc service entrance raceway & #6 thhn conductors. Replace 3 4" rmc branch circuits raceway & #12 thhn conductors . Amp service panel & meter socket as per code.

Amend permit com2009-06057 issued on 03 27 09 with plans #2009-3 to add electrical contractor as listed above. Original permit description:(com2009-06057)amend permit # com2008-33329 issued on 1 13 09 with plans # 2008-1725 to add the following additional work extension pole on the existing monopole per bmza 706-08 approved 11 14 08 as per plans as per code. Original permit description:(com2008-33329)proposed unmanned equipment shelter and standby generator on grade with (12) antennas mounted on existing monopole tower as per plans as per code. If installing suppression system in equipment cabinet(s) then a separate permit is required.

Amend permit#com2009-06057 issued on 3 27 09 with plans #2009-3 to add contractor as listedoriginal permit description:(com2009-06057)amend permit # com2008-33329 issued on 1 13 09 with plans # 2008-1725 to add the following additional work extension pole on the existing monopole per bmza 706-08 approved 11 14 08 as per plans as per code. Original permit description:(com2008-33329)proposed unmanned equipment shelter and standby generator on grade with (12) antennas mounted on existing monopole tower as per plans as per code. If installing suppression system in equipment cabinet(s) then a separate permit is required.

Tmemporary construction permit for service2 amp120 240