Site:site improvement for ex containment terminal

Demolition of exst billboard sign line 125

Demolition of exst billboard sign / line 125

Demolition of exst billboard sign line 125

Demolition of exst billboard sign line 118

Demolition of exst billboard sign / line 118

Demolition of exst billboard sign line 118

Complaint investigation

Complaint/investigation

Non-struct res remodel

Upgrade lte antennas on existing cell tower

New restroom build on property

60amp meter for brighthouse power supply cabinet

Commercial alteration

(... Work shall include but not be limited to) demolition, removal and replacement of the existing primary sludge motor control center, (2) three phase transformers, a single phase and three phase panel board, lighting fixtures, (and all associated work required fo a complete in accordance with the contract...)

Bldg 62 packaged unit change-out equal change-out

Bldg package unit equal change out

Existing starters and conductors, install three (3) new softstarters including power factor correcting, install three (3) new softstarters including power factor correcting capacitors, cables, conductors, conduit and all appurtenant work.

Bldg 63 package unit change-out like for like

Bldg 19 split system equal change-out

Bldg 54 split system equal change out

Bldg 32 split equal change out

Bldg 35 two splits equal change out

Scope: {... Work shall include but not be limited to } electrical demolition, removal and replacement of the existing hfc awtp digestion control building a motor control center mcc-62, a control cabinet, gas detector, and magnetic flow meter.

Work shall include but not be limited to electrical demolition, removal and replacement of the existing three-phase 480v switchgear 56; perform a short circuit coordination study for the proposed switchgear.

Work shall include but not be limited to } furnish and provide all labor, materials, and equipment to reconstruct sludge drying beds no. 24 and no. 32 at the howard f. Curren awtp as shown on the plans. Remove and replace drainage laterals (6) and drainage main lines (12). Remove and replace approximately 30,0 square feet (4 layers) of filtering media and fabric. { and all associated work required for a complete project in accordance with the contract.

Furnishing all labor, materials, and equipment to remove and replace (3) mixer motors, (3) gearboxes, 42 diameter return sludge pipe, (2) knife gate valves, (1) 24 knife gate valve, (3) butterfly valves, (3) 24 flow meters and (1) actuator. Reconnect existing (2) actuators to new butterfly valves. Remove, store, and reinstall existing mixer (ur-ma-15) to facilitate construction. Contractor shall furnish all labor, materials, and equipment to modify the existing mixer shafts and replace worn or broken impeller blades and hubs to be supplied by the city. Work also includes painting and all associated electrical work.

Pre-fabricated metal buildings

Furnishing all labor, materials and equipment to remove and replace aeration diffusers, mixers, vegetation, and associated appurtenances within reactor no. 1, install internal recycle pump, backflow device, crane davit, and associated piping and appurtenances, install water quality probes (nitrate, ammonium, ph, do) , plc, air metering devices, and all associated electrical conduits, panels, and wiring, perform programming to automatically adjust air flow and internal recycle based on probe conditions defined by cot, perform scada integration,

Work shall include but not be limited to electrical demolition, removal and replacement of the existing three-phase 480v switchgear 56; perform a short circuit coordination study for the proposed switchgear.

Furnishing all labor, materials, and equipment to remove and replace (3) mixer motors, (3) gearboxes, 42 diameter return sludge pipe, (2) knife gate valves, (1) 24 knife gate valve, (3) butterfly valves, (3) 24 flow meters and (1) actuator. Reconnect existing (2) actuators to new butterfly valves. Remove, store, and reinstall existing mixer (ur-ma-15) to facilitate construction. Contractor shall furnish all labor, materials, and equipment to modify the existing mixer shafts and replace worn or broken impeller blades and hubs to be supplied by the city. Work also includes painting and all associated electrical work.

Scope: {... Work shall include but not be limited to } electrical demolition, removal and replacement of the existing hfc awtp digestion control building a motor control center mcc-62, a control cabinet, gas detector, and magnetic flow meter.

Work shall include but not be limited to } furnish and provide all labor, materials, and equipment to reconstruct sludge drying beds no. 24 and no. 32 at the howard f. Curren awtp as shown on the plans. Remove and replace drainage laterals (6) and drainage main lines (12). Remove and replace approximately 30,0 square feet (4 layers) of filtering media and fabric. { and all associated work required for a complete project in accordance with the contract.

Installation of new fire alarm system per the shop drawings. Facp, smokes, ducts, sprinkler monitor, notification devices. This is the waste water division.

Reissue furnishing all labor, materials and equipment to remove and replace aeration diffusers, mixers, vegetation, and associated appurtenances within reactor no. 1, install internal recycle pump, backflow device, crane davit, and associated piping and appurtenances, install water quality probes (nitrate, ammonium, ph, do) , plc, air metering devices, and all associated electrical conduits, panels, and wiring, perform programming to automatically adjust air flow and internal recycle based on probe conditions defined by cot, perform scada integration, original date of application 02 25 2016

Reissued:work shall include but not be limited to electrical demolition, removal and replacement of the existing three-phase 480v switchgear 56; perform a short circuit coordination study for the proposed switchgear. Originally issued 10-12-16

Reissued:existing starters and conductors, install three (3) new softstarters including power factor correcting, install three (3) new softstarters including power factor correcting capacitors, cables, conductors, conduit and all appurtenant work. Originally issued 11-10-15.

Reissued:furnishing all labor, materials, and equipment to remove and replace (3) mixer motors, (3) gearboxes, 42 diameter return sludge pipe, (2) knife gate valves, (1) 24 knife gate valve, (3) butterfly valves, (3) 24 flow meters and (1) actuator. Reconnect existing (2) actuators to new butterfly valves. Remove, store, and reinstall existing mixer (ur-ma-15) to facilitate construction. Contractor shall furnish all labor, materials, and equipment to modify the existing mixer shafts and replace worn or broken impeller blades and hubs to be supplied by the city. Work also includes painting and all associated electrical work. Originally issued 11-09-16

Reissue: (... Work shall include but not be limited to) demolition, removal and replacement of the existing primary sludge motor control center, (2) three phase transformers, a single phase and three phase panel board, lighting fixtures, (and all associated work required fo a complete in accordance with the contract...)

Work shall include but not be limited to } furnish and provide all labor, materials, and equipment to reconstruct sludge drying beds no. 24 and no. 32 at the howard f. Curren awtp as shown on the plans. Remove and replace drainage laterals (6) and drainage main lines (12). Remove and replace approximately 30,0 square feet (4 layers) of filtering media and fabric. { and all associated work required for a complete project in accordance with the contract. Reissued: originally issued on 11-14-16

Scope: {... Work shall include but not be limited to } electrical demolition, removal and replacement of the existing hfc awtp digestion control building a motor control center mcc-62, a control cabinet, gas detector, and magnetic flow meter. Reissued:originally issued 08-29-16

Work shall include but not be limited to } furnish and provide all labor, materials, and equipment to reconstruct sludge drying beds no. 24 and no. 32 at the howard f. Curren awtp as shown on the plans. Remove and replace drainage laterals (6) and drainage main lines (12). Remove and replace approximately 30,0 square feet (4 layers) of filtering media and fabric. { and all associated work required for a complete project in accordance with the contract. Reissued: originally issued on 11-14-16

Installation of two (2) hp booster pumps and two (2) 7. 5 hp booster pumps including all accessory equipment, valve assemblies, electrical connections and appurtenances in screen & grit buildings nos. 1 & 2.

Replacement of backflow preventor wilkins 2" device located by small office. Mr

Repair replace meter can, lugs and cooper wire with same due to vandalism.

Repair/replace meter can, lugs and cooper wire with same due to vandalism.

2 amps overhead service upgrade a c 3 ton kw

2 amps overhead service upgrade a/c 3 ton kw

We need a tree consultation regarding the roots of an oak tree that are uprooting the granite curb and brick pavers in the driveway entrance to our office building.

Edr-beam replacement(120sf)

Demo and removal of double wide modular building

Relocate ex billboard sign d f illum

Relocate ex billboard sign d/f illum

Relocate ex billboard sign d f illum

Commercial alteration

Commercial alteration