(use)the premises for single family dwelling

Install sump pump for existing pit as per code

One full ductwork system with 75 0 btu gas fired furnace with 2 tons of a/c on roof. Gas to be done by others. All work to be done as per city/code.

Non-structural alterations - exterior work - remove formstone/ clean and repoint existing brick as per code

Install new water and waste for 3 toilets 3 vanitys 1 shower 1 bathtub 1 laundry 1 kitchen sink disposal dishwasher 2 hose bibbs 1 icemaker 1 electric hwh 1 gas furnace 85k btus 1 gas dryer 45k btu as per code. Hvac by others

Wire 1 house to code. Install (1) 1 amp service. Install 6 low voltage. Install circuits. Install fixtures or devices as per code.

Non-structural alterations/interior work 108 sq. Ft. - digging an interior french drain that is x 26 as per code.

"structural alterations/ interior work 229 sq. Ft. - underpinning basement per engineer drawings. All work is per code. Replace (16-8"") of foundation walls as per attached engineer plans & cert. The engineer cert. Reg. At completion of work with report of"

To construct 2nd floor rear addition 87x136x169 w/ 2x6 exterior bearing walls r insulation @ walls r49 @ roof interior doors 3 windows 4 complying with egress requirements interior partitions 2x4 @ 24 o. C. Dyrwall flooring and finishes as per

Interior work 702 sqft exterior work category ii: remove portion of rear first floor and reconstruct with 228 sqft new footings 87x7 and 136x169 ad new 2x6 exterior bearing walls r insulation in walls r49 in roof. Interior alterations including new

Category1: non structural alterations: interior 932 sq ft: demo all plaster walls and sheetrock. Remove old kitchen and bathrooms down to study. Work on 1st and 2nd floor. Separate permit required for tenant fit out.

Interior work 28 sqft: remove all drywall plaster carpet window treatments windows damaged roofing & damaged subfloor. Remove existing stairs interior partitions non bearing walls existing plumbing electrical wires hvac 3 levels to include b

Interior work 28 sqft: remove all drywall plaster carpet window treatments windows damaged roofing & damaged subfloor. Remove existing stairs interior partitions non bearing walls existing plumbing electrical wires hvac 3 levels to include basement separate permit required for tenant fitout as per code

To construct 2nd floor rear addition 87x136x169 w/ 2x6 exterior bearing walls r insulation @ walls r49 @ roof interior doors 3 windows 4 complying with egress requirements interior partitions 2x4 @ 24 o. C. Dyrwall flooring and finishes as per sketch and as per code

Interior work 702 sqft exterior work category ii: remove portion of rear first floor and reconstruct with 228 sqft new footings 87x7 and 136x169 ad new 2x6 exterior bearing walls r insulation in walls r49 in roof. Interior alterations including new 2x4 partition drywall cabinets flooring interior doors 7 exterior doors 2 windows 7 in same size and location as per sketch & as per code

Structural alterations/ interior work 229 sq. Ft. - underpinning basement per engineer drawings. All work is per code. Replace (16-8") of foundation walls as per attached engineer plans & cert. The engineer cert. Reg. At completion of work with report of the exact dates of periodic inspection during construction. Existing height 2-6" and proposed height is 2-6" as per sketch/code. Excavation & placement of concrete must be done under direction of a structural engineer as indicated on the certification of the work filed with approved plans. Engineer as indicated on the certification of work and inspection dates. Inspect with official within days of completion as per drawing/code.

To construct 2nd floor rear addition 87x136x169 w 2x6 exterior bearing walls r insulation @ walls r49 @ roof interior doors 3 windows 4 complying with egress requirements interior partitions 2x4 @ 24 o. C. Dyrwall flooring and finishes as per sketch and as per code

Structural alterations interior work 229 sq. Ft. - underpinning basement per engineer drawings. All work is per code. Replace (16-8") of foundation walls as per attached engineer plans & cert. The engineer cert. Reg. At completion of work with report of the exact dates of periodic inspection during construction. Existing height 2-6" and proposed height is 2-6" as per sketch code. Excavation & placement of concrete must be done under direction of a structural engineer as indicated on the certification of the work filed with approved plans. Engineer as indicated on the certification of work and inspection dates. Inspect with official within days of completion as per drawing code.

Non-structural alterations interior work 108 sq. Ft. - digging an interior french drain that is x 26 as per code.

Non-structural alterations - exterior work - remove formstone clean and repoint existing brick as per code

One full ductwork system with 75 0 btu gas fired furnace with 2 tons of a c on roof. Gas to be done by others. All work to be done as per city code.