Get several free quotes from best contractors in your area.
| Content | Date | Cost | Contractor Rank | Address | Contractor |
|---|---|---|---|---|---|
Install (3) hybrid cables (3) new fiber cables (3) new panel antennas (3) new remote radio units as per plans and as per code. Plans were previously approved under permit #com2014-02915 issued on 04/29/14. Plans #2014-300. Permit id: Com2015-00280 | |||||
Replace damaged service conductors 2 amp cable asper code. Permit id: Com2014-13305 | |||||
Remove and replace existing antennas on existing structure. Antenna will be located at same rad center as existing. Retrofit in existing equipment cabinet at existing location. As per plans and code. If installing suppression system in equipment cabinet t Permit id: Com2012-09577 | |||||
Remove/replace 2 unmanned equipment cabinets on grade. Remove/replace 3 antennas on rooftop. Add 3 antennas on rooftop. As per plan and as per code. If installing suppression system in equipment cabinet then a separate permit is required. Permit id: Com2011-23737 | |||||
Existing telecommunications equipment on site per plans - clearwire proposes to install (1) microwave dish antenna as per plans as per code. If installing suppression system in equipment cabinets then a separate permit will be required. Permit id: Com2009-13284 | |||||
Remove existing emon-demon meter install new 1 amps breaker in existing meter srack to feed telephoneequipment cabinets as per code Permit id: Com2008-26449 | |||||
Upgrading existing 70amp to 100amp service. Permit id: Com2008-26199 | |||||
Remove and replace 4 antennas pcs and 2 telecommunitcation cabinets. Add 2- amp 2 volt circuits. Extend telco conduits and tie to existing ground ring. System upgrade only as per plan as per code. Permit id: Com2007-36251 | |||||
Install gas furance 1 0 btu to replace exist. Approved for work only. C/o required Permit id: Com2005-00061 | |||||
Remove and replace existing antennas on existing structure. Antenna will be located at same rad center as existing. Retrofit in existing equipment cabinet at existing location. As per plans and code. If installing suppression system in equipment cabinet then a separate permit is required. Expiration date: May 21, 2013 | Permit id: Com2012-09577 | |||||
Install (3) hybrid cables (3) new fiber cables (3) new panel antennas (3) new remote radio units as per plans and as per code. Plans were previously approved under permit #com2014-02915 issued on 04 29 14. Plans #2014-300. Expiration date: July 7, 2015 | Permit id: Com2015-00280 | |||||
Install new hvac system in enclosed telecommunications equipment penthouse install new disconnect switch and condenser unit on exterior wall of equipment penthouse(no changes to antennas) as per plans as per code. Expiration date: February 23, 2018 | Permit id: Com2017-13004 | |||||
Install gas furance 1 0 btu to replace exist. Approved for work only. C o required Expiration date: July 3, 2005 | Permit id: Com2005-00061 | |||||
Remove replace 2 unmanned equipment cabinets on grade. Remove replace 3 antennas on rooftop. Add 3 antennas on rooftop. As per plan and as per code. If installing suppression system in equipment cabinet then a separate permit is required. Expiration date: May 30, 2012 | Permit id: Com2011-23737 |