Use premises as a clothing boutique 1st floor (suite # 105)

(use) retail store for herbal soaps and silk scarves and sell of unisex clothes (suite# 105)

Replace toilet and wall hung lav with new as per code.

Add (3) antennas. Swap (1) amp breaker with (1) amp breaker as per plans and as per code.

Continue to use as a beauty salon change of ownership

Original permit description:(com2014-00201)install antennas and related equipment on existing rooftop per bmza 2013-488 approved 1/14/2014 as per plans and as per code. If installing suppression system in equipment cabinet then a separate permit is requir

Install antennas and related equipment on existing rooftop per bmza 2013-488 approved 1/14/2014 as per plans and as per code. If installing suppression system in equipment cabinet then a separate permit is required.

Exterior work: remove and replace existing antennas on existing structure antenna will be located at same rad center as existing swap (1) equimpent cabinet at existing location as per plans as per code. If installing suppression system in equipment cabin

Adt security services inc 7 points of low voltage security devices burgular alarm. As per code.

Install (1) 2 microwave dish antenna to existing rooftop telecom site as per plans and as per code. If installing suppression system in equipment cabinet then a separate permit will be required.

(use) use portion of premises of 1st floor a hair salon

Install (3)three plumbing fixtures reconstruct wate & waste as per code

Install 1 ckts for 6 receptacles fished ininstall 1 low voltage for thermostat fished in as per code

Request for time extension on permit com2008-18098 issued on 08/06/08 with original completion date of 02/06/09. Original permit description:(com2008-18098)frame interior partition 33 long high with metal stud covered w/drywall install two flush do

Frame interior partition 33 long high with metal stud covered w/drywall install two flush doors. Install gfi ex fan/light and 2 switches. Unless this office (planning department) gets an elevation certificate to demonstrate otherwise then the fir

Use portion od 1st floor ofr theraputic massage yoga classes and pilates classes

Install 5 new handsinks 2 floor drains/ primers as per code.

Interior build out of tenant space including metal stud framing insulation drywall acoustical ceilings ductwork electrical and finishes as per plan as per code.

"build a dividing non-structural wall l x 12 h to separate retal space from offices. 5/8"" fire code drywall & 3 5/8"" metal studs o. C. Hang suspended ceiling w 2 x 4 grid as per code."

Replace exist frontdoor with glass alumiun frame door replace 4 windows with larger insulated glass windows reinstall 4 windows frame front to rear install 2 2x4 fixed glas windows on rear install 2 4x4 fixed glass windows on rear install 4 2x 9 fixe

Category 1 demo; remove exsiting restaurant equipment seating ceiling and interior walls. As per code.

Use suite # 1 for a restaurant

New fire alarm system. 1 annocator 1 annsole system.

Relocating of 1 gas line and 1 mop sink along w/the replacement of 6 toilets and 6 lavys and 2 urinals. As per code.

Amend permit# com2005-17746 issued on 7/19/05 with plans# 2005-833 to add electrical contractor listed above.

Install wet chemical fire system in kitchen exhaust hood

Amend permit#com2004-09774 issued 5-21-04 w/plans#2004-531 to name electricl contractor as stated above.

Commerical kitchen rebuild including all equipment new hood finishes walk-in boxes etc also minor seating area improvements misc new walls h/c ramp finishes etc as per plans. A. Provided the bar consist of the following: 1. A hand sink for hand w

Amend permit # com2004-09774 withn plan # 2004-531 to extend completion date to 10/22/05

Amend permit com2004-25377 issue 10/12/04 expires on 4/12/05 to extend to 10/12/05.

Install railing refurbish stairs as per plans

Removal of interior non bearing wall new floor and trim. Interior finishes and painting. No structural changes interior or exterior. No plumbing electrical or mechanical work. The scope of work must be as indicated above.

Request for time extension on permit com2008-18098 issued on 08/06/08 with original completion date of 02/06/09. Original permit description:(com2008-18098)frame interior partition 33 long high with metal stud covered w/drywall install two flush doors. Install gfi ex fan/light and 2 switches. Unless this office (planning department) gets an elevation certificate to demonstrate otherwise then the first floor walls must be cement board or other material resistent to water damage. Unless this office (planning department) gets an elevation certificate to demonstrate otherwise then the first floor walls must be cement board or other material resistent to water damage.

Frame interior partition 33 long high with metal stud covered w/drywall install two flush doors. Install gfi ex fan/light and 2 switches. Unless this office (planning department) gets an elevation certificate to demonstrate otherwise then the first floor walls must be cement board or other material resistent to water damage. Unless this office (planning department) gets an elevation certificate to demonstrate otherwise then the first floor walls must be cement board or other material resistent to water damage.

Exterior work: remove and replace existing antennas on existing structure antenna will be located at same rad center as existing swap (1) equimpent cabinet at existing location as per plans as per code. If installing suppression system in equipment cabinet then a separate permit is required.

Replace exist frontdoor with glass alumiun frame door replace 4 windows with larger insulated glass windows reinstall 4 windows frame front to rear install 2 2x4 fixed glas windows on rear install 2 4x4 fixed glass windows on rear install 4 2x 9 fixed glass windows on side replace exist rear door as per code

Build a dividing non-structural wall l x 12 h to separate retal space from offices. 5/8 fire code drywall & 3 5/8" metal studs o. C. Hang suspended ceiling w 2 x 4 grid as per code. "

Original permit description:(com2014-00201)install antennas and related equipment on existing rooftop per bmza 2013-488 approved 1/14/2014 as per plans and as per code. If installing suppression system in equipment cabinet then a separate permit is required.

Install nine (9) panel antennas on roof of existing multi-story commercial/office bldg. Antennas are to be sled-mounted in three (3) groups of three (3) antennas each. Also construct a 10x steel platform used to support modular radio cabinets (unmanned) per bmza 110-04 approved march 2004

Amend permit#com2004-09774 issued n 5-21-04 w/plans#2004-531 to name elelctrical contractor as stated above.

Commerical kitchen rebuild including all equipment new hood finishes walk-in boxes etc also minor seating area improvements misc new walls h/c ramp finishes etc as per plans. A. Provided the bar consist of the following: 1. A hand sink for hand washing and 2. A 3-compartment sink with indirect plumbing (minimum 2-inch air gap) for each compartment for cleaning bar glass/utensils. B. Provided this facility adheres to the plumbing codes attached with soil or drain pipes located over food preparation storage display bar serving or dining areas

Use portion 1st floor for therapeutic massage aesthetics services and retail clothing and skin care products.

Installation of security system devices as per code

Build a dividing non-structural wall l x 12 h to separate retal space from offices. 5/8" fire code drywall & 3 5/8" metal studs o. C. Hang suspended ceiling w 2 x 4 grid as per code.

Non-structural alterations exterior work-reface non-illuminated panel on freestanding sign for an allstate logo sign (7. 25" x 53. 75" = 2. 7 square feet) as per plans as per code.

Build a dividing non-structural wall l x 12 h to separate retal space from offices. 5 8" fire code drywall & 3 5 8" metal studs o. C. Hang suspended ceiling w 2 x 4 grid as per code.

Install 5 new handsinks 2 floor drains primers as per code.

Frame interior partition 33 long high with metal stud covered w drywall install two flush doors. Install gfi ex fan light and 2 switches. Unless this office (planning department) gets an elevation certificate to demonstrate otherwise then the first floor walls must be cement board or other material resistent to water damage. Unless this office (planning department) gets an elevation certificate to demonstrate otherwise then the first floor walls must be cement board or other material resistent to water damage.

Request for time extension on permit com2008-18098 issued on 08 06 08 with original completion date of 02 06 09. Original permit description:(com2008-18098)frame interior partition 33 long high with metal stud covered w drywall install two flush doors. Install gfi ex fan light and 2 switches. Unless this office (planning department) gets an elevation certificate to demonstrate otherwise then the first floor walls must be cement board or other material resistent to water damage. Unless this office (planning department) gets an elevation certificate to demonstrate otherwise then the first floor walls must be cement board or other material resistent to water damage.

Amend permit com2004-25377 issue 10 12 04 expires on 4 12 05 to extend to 10 12 05.

Amend permit # com2004-09774 withn plan # 2004-531 to extend completion date to 10 22 05

Commerical kitchen rebuild including all equipment new hood finishes walk-in boxes etc also minor seating area improvements misc new walls h c ramp finishes etc as per plans. A. Provided the bar consist of the following: 1. A hand sink for hand washing and 2. A 3-compartment sink with indirect plumbing (minimum 2-inch air gap) for each compartment for cleaning bar glass utensils. B. Provided this facility adheres to the plumbing codes attached with soil or drain pipes located over food preparation storage display bar serving or dining areas

Amend permit# com2005-17746 issued on 7 19 05 with plans# 2005-833 to add electrical contractor listed above.

Relocating of 1 gas line and 1 mop sink along w the replacement of 6 toilets and 6 lavys and 2 urinals. As per code.

Amend permit#com2004-09774 issued 5-21-04 w plans#2004-531 to name electricl contractor as stated above.

Install antennas and related equipment on existing rooftop per bmza 2013-488 approved 1 14 2014 as per plans and as per code. If installing suppression system in equipment cabinet then a separate permit is required.

Original permit description:(com2014-00201)install antennas and related equipment on existing rooftop per bmza 2013-488 approved 1 14 2014 as per plans and as per code. If installing suppression system in equipment cabinet then a separate permit is required.

Install nine (9) panel antennas on roof of existing multi-story commercial office bldg. Antennas are to be sled-mounted in three (3) groups of three (3) antennas each. Also construct a 10x steel platform used to support modular radio cabinets (unmanned) per bmza 110-04 approved march 2004

Amend permit#com2004-09774 issued n 5-21-04 w plans#2004-531 to name elelctrical contractor as stated above.