Alteration: interior plumbing of a commercial space used for retail sales of consumer goods (space #1) and accessory use to provide personal services, in an existing shopping center. The installation shall comply with the philadelphia plumbing code, 2004. The use of plastic pipe materials is not permited, per code section(s) p-902. 5, p-1005. 5, p-1102. 3 & code bulletin no. 0901 r3. Fuel gas piping is not part of this permit and requires a mechanical permit.

Interior plumbing construction for a tenant fit-out (americas best contacts & eyeglasses) - ss-1 service mop sink is required to have a 3" trap and fixture waste per tables p-506 and p-904. 7, house drains receiving the discharge from water closets must be a minimum of 4" in pipe size per p-904. 5. 1, venting of fixtures connected to the house drain must comply with section p-1110. 3 of the philadelphia plumbing code 2004 - the installation will comply with the approved plans "as noted" and the philadelphia plumbing code 2004

Provide and install 2 roof top units and curbs. Insulate duct, perform balance. System designed for future tenant.

Furnish and install (1) water closet, (1) lavatory, (1) mop sink, and (1) kitchen sink, connect to existing services. (verizon store)

Use change from a restaurant to a public fios store.

Install new wall sign illuminated "verizon", apply vinyl stickers on the main doors ( verizon, store hours and no pets ). New tenant panels on existing pylon signs and new ceiling blade sign under the canopy.

Interior alterations as per plans

Reuse existing service. Install 37 light fixtures, 5 switches, 4 lighted mirror connections & 2 tele data outlets. Relocate 21 fixtures & feed connect 4 motorized doors.

Fixture replacements

Relocate 4 sprinkler heads - store #736 (tj max)

Replacement wall sign led letterset for bank

Remodel interior space with 67 light fixtures, 23 receptacles, power to hvac equipment, power to mri equipment, 35 emergency and exit lights, and 38 light switches, as per 2005 nec (west dist)

Interior renovations.. (2) water closets, (3) lavatories, (2) floor drains, mop receptor, hot water heater

Remove existing signs and awnings. For the erection of ten (10) single-faced, internally illuminated awning signs, four (4) internally illuminated single-faced flatwall signs, one (1) non-illuminated single faced flatwall sign, and one (1) double faced internally illuminated directional sign as per plans.

Removal and installation of standing seam roof as per plans.

Install - cat6 plenum rated cable for tele data 105 longest drop as per 2008 nec (west district)

Tenant fit out.

Reuse existing service, install new panels, 95 light fixtures, receptacles, 4 cash wraps, 6 phone lines, energy management system panel wiring, 8 exit signs & 12 emergency lights.

Tenant alterations: 2 wc, 2 lavs, 2 f. D., 1 drink f, 1 service sink.

For the installation of an exhaust and associated make-up air system only. Field verification of existing hvac system to be required.

Installation of fa system consisting of fire alarm control panel,annuciateor,21 smoke detectors,3 duct detectors,7 strobes,4 horn strobes,3 manual pull stations. Class 2 low voltage wiring both concealed and in conduit per nfpa 72 (commercial)

For the interior alteration of an existing space to include wall, floor, ceiling finishing, new partitions, accessible bathroom and accessible service counter. (iebc 2009, compliance path: work-area method, lvl iii alterations)

Interior alterations to include new non load bearing partitions, ada restrooms, interior lighting work, upgrades to finishes, and all other work as per approved plans to create a vacant commercial space. Separate permit required for mechanical, electrical, and plumbing work. Use registration permit and certificate of occupancy required

Tenant space #16 for use as retail sales of wearing apparel & accessories and sole medical, dental & health practitioner office. No change in use of any other tenant spaces, no change in parking, no signs on this application.

For the interior alterations (tenant space 16) to include the demolition and erection of non-bearing partitions, finishes and millwork. Space for use as sole medical practitioners office and retail sales of glasses and contacts. All work per approved plans. Separate permit required for mechanical, electrical and fire suppression.

Interior demolition of non bearing partitions

Repair damages brick hit by vehicle. Repair damaged glass. Permit application in response to unsafe violations # 459576 to comply violation, completed work is to be inspected and approved as an appropriate repair to each violation. Engineers report submitted. Licensed contractor to assume responsibility of work. No other work this permit. Separate permits required for renovation. Contact streets department for dumpster and or footway closure permits.

Install 200amp 3 phase service wire 17 lights,6 switches,14 receptacles,4 outlets,2 walk in cooler freezer 2 exhaust fan and make up air fan motor 5 emergency light and 1 a c outlet per 2008 nec. Bonding conductors to comply with article 250. 102(c)#4 not #6.

Install 1 set of internally illuminated channel letters to store front. Install 1 rear service entrance door sign.

Install a 3-7 1 2" x 22-6" flat wall channel letters sign.

Ez standard kitchen fire suppression- for the installation of new wet chemical kitchen hood fire suppression system as per attached standard. Deviations from this standard will result in permit revocation and require submission of construction plans.

Install 76 lights, 8 emergency lights, 1 remote head, 15 gfcis, 16 recps, 21 switches & fan circuits.

1 accessory sign flat wall sign

Rooftop - site 1ph2312 (electrical alterations) - upgrade wiring to #6 and breaker from 50amp to 60amp

Interior fit out to include demo of stock room walls, demising wall surface materials, restrooms and for the construction of new interior perimeter walls, exterior columns, rear doors, bollards, awning, vestibule, concrete ramps, and structural supports for new rtus installed under mechanical permit #762600.

Channel letters flat on wall

Inside branch circuits& switches to existing panel - tenant fit out as per nec 2008

Install 1 water closet 1 lav,2 hand sink,1-3 compartment sink,1 food prep sink,1 mop sink,3 floor drain,2 indirect drain and 1 grease trap (restaurant)

(applicant agrees to ez limited commercial alterations standard). Level 1 alteration: shall comply with the provisions of chapter 6 of the international existing building code. To include the removal and replacement or the covering of existing materials, elements, equipment or fixtures using new materials, elements, equipment or fixtures that serve the same purpose. For interior alterations to renovate an existing space #11. This work activity shall be performed by contractors & sub-contractors licensed by the city of philadelphia. Contact inspector at district office prior to starting work. Separate permits required for plumbing, electric and hvac.

Tenant fit out. Add new outlet locations, new switching for existing lights per 2008 nec (vision center)west district

Rough plumbing for pedicure chairs,2 hand sinks,1 mop sink and 1 water heater,install hot and cold to fixtures-the installation will comply with the philadelphia plumbing code 2004

Channel letters flat on wall.

Facade bump up at (3) locations w storefront glass on (2) locations.

Modify existing facade including raiising height of parpaet at front edge of canopy as part of an existing shopping center. No signage included on this permit.

For the replacement of one appliance in the kitchen area of a previously approved restaurant. Mechanical appliance to be installed in accordance with manufacturers specifications. All work to be done per approved plans. If field conditions vary contact design professional prior to the start of any work. Separate permits required for all other work.

Install branch circuits fed from landlord supplied exisiting service and installed gear, install outlets,lighting and rough data telephone locations box pine as per 2008 nec (west district)

Tenant fit out to create a verizon fios store in an existing space. No change to building footprint.

Furnish and install (6) duplex receptacles utilizing existing circuitry, no new circuiting required as per 2008 nec (west dist)

Relocate receptacles and add (1) receptacle for atm upgrade, rework security raceway path, as per 2008 nec (west dist)

Make safe permit - for rebuilding non load bearing wall with like in kind materials.(safety glass)must be installed, to resolve case #578943. Abutting sidewalk must be closed with fencing a minimum of 6? In height. Separate streets department permit required for sidewalk closure. A separate permit is required for any additional alterations that are not specifically addressed on case #578943.

Installation of 1 set of internally illum. Channel letters front elevation

800amp service with transformer,4 sub panels,4 rtus,3 exits,1 emg light,2 sign jb 2 awning lights and 1 vestibule light per 2008 nec (retail)

Demo lt and recept powr. F&i new lt fix and lt control panel, new recept por locations and powr for mech equip. Rough in work for data locations as per 2008 nec(commercial retail space)(west dist)

Hvac alterations to existing retail space, as per plans.

For the installation of one flat wall sign (static illumination) and for the reface of a double faced wall sign located under building canopy. Size and location as shown per approved plans. Sign accessory to retail sale of consumer goods with all other uses as previously approved in existing shopping mall.

Fast form building permit

For the erection of one (1) accessory flat wall sign accessory to a take out restaurant with seating in space # 21 as part of an existing shopping center.(size and location as shown in the application).

Install 29-outlets,2-exhaust fans,water heater,42-lights,8-switches,2-exit signs and feed a 200amp panel from an existing 200amp service disconnect as per 2008 nec (west district)

Install four roof-top units and and a rooftop exhaust fan and interior demo of exiting ductwork. See permit #762048 for tenant fit-out work and structural modifications for the support of the new rtus. Separate electrical permit required.

Construct new facade enhancement over space #16. Work consist of removing existing sign finishes, reframe to mee design and appl dryvit finish.

Relocate 6 existing recepts and circuits to the location of the new cash register line up as per 2005 (west district)

Amend permit #715966 to reduce scope of facade work for work area #1 as shown on plans approved under ap #762048.

Install vent & water piping for 4 sinks (vision center)the installation will comply with the philadelphia plumbing code 2004

For the installation of one internally illuminated flat wall channel letter sign (35- 7 16" x 30") existing electric and one flat wall 18" x 6".

Install one channel letter sign, 2 by 18 for omnia nail spa.

For the erection of one (1) flatwall channel letter sign (41x4). Size and location as shown in the application. One (1) sign accessory to an existing retail sale of general merchandise with accessory sale of prepackaged foods in space #1 within an existing shopping center.

For the installation of three (3) wall signs on an existing detached structure and the replacement of two (2) tenant panels in an existing freestanding sign. Separate permits required for electrical systems. Separate permits required for awning signs.

Install one set of illum letters on raceway.

Construction for the installation of a new atm for bank. Scope of work includes; cutting exterior wall , patch exterior wall and steel support under atm.

Remove and replace 6 antennas, install 3 lines of outedoor rated fiber optic cables 2 1 1 from antennas to existing steel platform on roof site #1ph2312c as per 2008 nec(cell site)(west dist)

Install 2 new radio cabinets on existing slabs using existing ele conduit . 50a and 30a nex cabs as per 2008 nec(commercial)(west dist)

For the installation of three (3) statically-illuminated wall signs on an existing detached structure and for the replacement of two (2) tenant panels of an existing double-faced freestanding sign. Size and location as shown in plans. For signage accessory to a retail sales of consumer goods store in an existing area shopping center. Separate permits required for awning signs.

Installing new cast iron drainage & copper water line for 2-landskinks, 1-wc, 1-3 compartment sink, 1-prep sink, 1-lav & 1-indirect waste (store)

Install (1) internally illuminated wall sign for verizon and install a new ceiling blade sign under canopy.

Security system and closed caption tv install including wiring & devices as per nec 2008 west district

Remove existing signs and awnings and install new signs

Install low voltage wiring in conduits provided by others for 2-security antennas at front door as per 2008 nec (west district)

Install ansul fire suppression systen type 1 hood. Additional permtis req: hood, electrical.

Installation of one, flatwall sign 37" by 226" for "payless shoesource"

For the erection of one (1) flatwall internally illuminated channel letter sign ( 176" x 3). Size and location as shown in the application. Sign accessory to an existing retail sale of beauty supplies in space #8 within an existing shopping center.