Reroofing

Reroofing

Unit 3: replace wall cabinets in kitchen in-kind small kitchen. Compliance with maher ordinance no. 155-13 not required.

New electrical replace kitchen cabinets in kind wall have no changes in wall & openings. Partial kitchen remodels

Addition of dwelling units at ground floor per ordinance no 30-15. Provide 3 additional dwelling units within existing building envelope lower (e) slab at storage by 24" max. Provide sprinklers in new units and egress paths under separate permit. Maher: n/a

#21: new electrical. Replace kitchen cabinets in kind wall hung. No change on walls and openings.

Soft story retrofit to comply with sfbc chp 34b using fema p807; maher n/a

Addition of dwelling units at ground floor per ordinance no 30-15. Provide 3 additional dwelling units within existing building envelope lower (e) slab at storage by 24" max. Provide sprinklers in new units and egress paths under separate permit

New electrical; new cabinets in kitchen. There are only 5 cabinets & some existing cabinets are staying place. New lighting to comply with cec 150(k). No new counter tops. No changes to wals windows ceilings or doors.

Reroofing

Soft story retrofit to comply with sfbc chp 34b using fema p807; maher n/a

Work @ unit# 24 & # 26 only. Replace existing kitchen. Cabinet sink & countertop in kind.

Street space permit only.

Work on unit##23. Replace 5 only kitchen cabinets in kind. Wall hung cabinets. Economical not custom.

Seismic upgrade

Street space

New electrical replace kitchen cabinets in kind wall have no changes in wall & openings. Partial kitchen remodels

Addition of dwelling units at ground floor per ordinance no 30-15. Provide 3 additional dwelling units within existing building envelope lower (e) slab at storage by 24" max. Provide sprinklers in new units and egress paths under separate permit. Maher: n a

Soft story retrofit to comply with sfbc chp 34b using fema p807; maher n a

Apt. #4. Install all new wiring remove fuses and use fuse box as junction and then install 8-16 panel in hall. Building is in rigid pipe remove all old cloth covered wire and install thhn. Bring bath and kitchen up to code requirements.

Complete re-wire of existing apartment. The apartment was originally installed with rigid pipe. Fuse box removed and new 8-16 sub-panel installed outside of closet. Entire apartment brought up to todays electrical code. This is apartment #21.

Install new 8-16 sub-panel in entry room and out of closet. Building is all in rigid pipe replace all old cloth wire with thhn and increase from two circuits to 9 circuits either gfi or arc fault protected. This is a small studio apartment approx. 4 square feet. This is apartment #25.

4 lights 4 switches 12 receptacles 1 microwave 3 wire #8 feeder 6 circuits 8-16 panel. New sub panel with new feeders. Kitchen bathroom circuits added replace old wiring with new wire in rigid pipe.

2nd flr: new wiring throughout this studio apt new sub -panel building is all in rigid pipe. This is apt #23- 1 sub-panel @ amps 6 circuits 5 lights 4 switches 9 receptacles

Apartment #22. Remove old fuse box in closet and install new 8-16 sub-panel. Install new sub-panel wires from main service which was 2 wire to 3 wire. Apartment is all in rigid piping replace all old cloth covered wire with new thhn. Install kitchen and bath circuits to current code and lighting and bedroom on arc-fault breakers. Replace electric heat - like for like.

3rd floor # 26: 5 lights 5 switches receptacles 1 dishwasher 1 microwave; panelboard: 1 sub-panel - amp. # 8 thhn; new sub-panel installed new wire pulled through existing rigid pipe. 5 new circuits installed for kitchen bath.

Apartments 1 & 2. Install new 8-16 sub-panels to replace fuse boxes and move out of closets. Replace old cloth covered wire with new thhn wire. Install bedroom and lighting circuits on arc-fault breakers.

1st flr: new electrical service- 16 apartments 1 house meter: 3 amps - 120-2 volt single phase overhead 3 wire-2 mcm 17 meters

Apartment #5. Remove fuses in closet and install new sub-panel in hallway. Back-feed existing circuits. Remove old cloth covered wire and replace with thhn. Install new electric heater like for like. This is in reference to complaint #201213301.

Apartment #3. Complete re-wire. Using old fuse panel in closet as junction box and moving to an 8-16 panel in main room. This apartment is approx. Only 2 square feet 1 kitchen 1 bath 1 room. Building is all in rigid pipe. Removing all old clothe covered wire and replacing with thhn. Installing circuits as per code. 22 unit building this is i believe the 14th or 15th apartment i have done.

Apartment #6. Replaced cloth covered wire with new thhn in existing rigid piping. Replaced fused electrical system with 8-16 panel and relocated to hallway. Installed kitchen and bath circuits as per code.

Apartment #28. This is one of the last apartments that i have completely re-wired. The building in all in steel rigid so replacing all old cloth covered wire and installing small sub-panel and circuits to bring up to code. These apartments are approximately 4 square feet.

Replacethesewerlateral

Work@unit#24onlly. Replaceexistingsinkinkind.

Apartment #5. Remove fuses in closet and install new sub-panel in hallway. Back-feed existing circuits. Remove old cloth covered wire and replace with thhn. Install new electric heater like for like. This is in reference to complaint #201213301.

1st flr: new electrical service- 16 apartments 1 house meter: 3 amps - 120-2 volt single phase overhead 3 wire-2 mcm 17 meters

Apartments 1 & 2. Install new 8-16 sub-panels to replace fuse boxes and move out of closets. Replace old cloth covered wire with new thhn wire. Install bedroom and lighting circuits on arc-fault breakers.

Apartment #22. Remove old fuse box in closet and install new 8-16 sub-panel. Install new sub-panel wires from main service which was 2 wire to 3 wire. Apartment is all in rigid piping replace all old cloth covered wire with new thhn. Install kitchen and bath circuits to current code and lighting and bedroom on arc-fault breakers. Replace electric heat - like for like.

2nd flr: new wiring throughout this studio apt new sub -panel building is all in rigid pipe. This is apt #23- 1 sub-panel @ amps 6 circuits 5 lights 4 switches 9 receptacles

4 lights 4 switches 12 receptacles 1 microwave 3 wire #8 feeder 6 circuits 8-16 panel. New sub panel with new feeders. Kitchen bathroom circuits added replace old wiring with new wire in rigid pipe.

Install new 8-16 sub-panel in entry room and out of closet. Building is all in rigid pipe replace all old cloth wire with thhn and increase from two circuits to 9 circuits either gfi or arc fault protected. This is a small studio apartment approx. 4 square feet. This is apartment #25.

Complete re-wire of existing apartment. The apartment was originally installed with rigid pipe. Fuse box removed and new 8-16 sub-panel installed outside of closet. Entire apartment brought up to todays electrical code. This is apartment #21.

Apt. #4. Install all new wiring remove fuses and use fuse box as junction and then install 8-16 panel in hall. Building is in rigid pipe remove all old cloth covered wire and install thhn. Bring bath and kitchen up to code requirements.

3rd floor # 26: 5 lights 5 switches receptacles 1 dishwasher 1 microwave; panelboard: 1 sub-panel - amp. # 8 thhn; new sub-panel installed new wire pulled through existing rigid pipe. 5 new circuits installed for kitchen bath.

Apartment #6. Replaced cloth covered wire with new thhn in existing rigid piping. Replaced fused electrical system with 8-16 panel and relocated to hallway. Installed kitchen and bath circuits as per code.

Apartment #3. Complete re-wire. Using old fuse panel in closet as junction box and moving to an 8-16 panel in main room. This apartment is approx. Only 2 square feet 1 kitchen 1 bath 1 room. Building is all in rigid pipe. Removing all old clothe covered wire and replacing with thhn. Installing circuits as per code. 22 unit building this is i believe the 14th or 15th apartment i have done.

Apartment #28. This is one of the last apartments that i have completely re-wired. The building in all in steel rigid so replacing all old cloth covered wire and installing small sub-panel and circuits to bring up to code. These apartments are approximately 4 square feet.

Per ordinance# 162-16, add 3 additional units converting 16 to 22 @ garage level. No exterior work. Windows south elevation only. Seismic upgrade under pa# 2015 01 27 6832. 3 adu under pa# 2016 07 05 1607. Maher: n a

Work @ unit# 24 & # 26 only. Replace existing kitchen. Cabinet, sink & countertop in kind.

Work on unit##23. Replace 5 only kitchen cabinets in kind. Wall hung cabinets. Economical, not custom.

New electrical; new cabinets in kitchen. There are only 5 cabinets & some existing cabinets are staying place. New lighting to comply with cec 150(k). No new counter tops. No changes to wals, windows, ceilings, or doors.

New electrical, replace kitchen cabinets in kind, wall have no changes, in wall & openings. Partial kitchen remodels

Unit 3: replace wall cabinets in kitchen in-kind, small kitchen. Compliance with maher ordinance no. 155-13 not required.

Addition of dwelling units at ground floor per ordinance no 30-15. Provide 3 additional dwelling units within existing building envelope, lower (e) slab at storage by 24" max. Provide sprinklers in new units and egress paths under separate permit. Maher: n a

Apartment #28. This is one of the last apartments that i have completely re-wired. The building in all in steel rigid, so replacing all old cloth covered wire and installing small sub-panel and circuits to bring up to code. These apartments are approximately 4 square feet.

1st flr: new electrical service- 16 apartments, 1 house meter: 3 amps - 120-2 volt, single phase, overhead, 3 wire-2 mcm, 17 meters

Apartment #3. Complete re-wire. Using old fuse panel in closet as junction box and moving to an 8-16 panel in main room. This apartment is approx. Only 2 square feet, 1 kitchen, 1 bath, 1 room. Building is all in rigid pipe. Removing all old clothe covered wire and replacing with thhn. Installing circuits as per code. 22 unit building, this is, i believe the 14th or 15th apartment i have done.

Apt. #4. Install all new wiring, remove fuses and use fuse box as junction and then install 8-16 panel in hall. Building is in rigid pipe, remove all old cloth covered wire and install thhn. Bring bath and kitchen up to code requirements.

Apartments 1 & 2. Install new 8-16 sub-panels to replace fuse boxes and move out of closets. Replace old cloth covered wire with new thhn wire. Install bedroom and lighting circuits on arc-fault breakers.

Apartment #5. Remove fuses in closet and install new sub-panel in hallway. Back-feed existing circuits. Remove old cloth covered wire and replace with thhn. Install new electric heater like for like. This is in reference to complaint #201213301.

Install new 8-16 sub-panel in entry room and out of closet. Building is all in rigid pipe, replace all old cloth wire with thhn and increase from two circuits to 9 circuits either gfi or arc fault protected. This is a small studio apartment approx. 4 square feet. This is apartment #25.

3rd floor, # 26: 5 lights, 5 switches, receptacles, 1 dishwasher, 1 microwave; panelboard: 1 sub-panel - amp. # 8 thhn; new sub-panel installed, new wire pulled through existing rigid pipe. 5 new circuits installed for kitchen bath.

Apartment #22. Remove old fuse box in closet and install new 8-16 sub-panel. Install new sub-panel wires from main service which was 2 wire to 3 wire. Apartment is all in rigid piping, replace all old cloth covered wire with new thhn. Install kitchen and bath circuits to current code and lighting and bedroom on arc-fault breakers. Replace electric heat - like for like.

2nd flr: new wiring throughout this studio apt, new sub -panel, building is all in rigid pipe. This is apt #23- 1 sub-panel @ amps, 6 circuits, 5 lights, 4 switches, 9 receptacles

Complete re-wire of existing apartment. The apartment was originally installed with rigid pipe. Fuse box removed and new 8-16 sub-panel installed outside of closet. Entire apartment brought up to todays electrical code. This is apartment #21.

4 lights, 4 switches, 12 receptacles, 1 microwave, 3 wire #8 feeder, 6 circuits, 8-16 panel. New sub panel with new feeders. Kitchen, bathroom, circuits added, replace old wiring with new wire in rigid pipe.

Apartment #6. Replaced cloth covered wire with new thhn in existing rigid piping. Replaced fused electrical system with 8-16 panel and relocated to hallway. Installed kitchen and bath circuits as per code.

Work @ unit# 24 & # 26 onlly. Replace existing sink in kind.

Replace the sewer lateral

Per ordinance# 162-16 add 3 additional units converting 16 to 22 @ garage level. No exterior work. Windows south elevation only. Seismic upgrade under pa# 2015 01 27 6832. 3 adu under pa# 2016 07 05 1607. Maher: n a

New electrical; new cabinets in kitchen. There are only 5 cabinets & some existing cabinets are staying place. New lighting to comply with cec 150(k). No new counter tops. No changes to wals windows ceilings or doors.