Elec work for new controlled environmental room and second floor office.

Extend existing wet pipe fire sprinkler system to area below new mezzanine in production area.

Extend existing wet pipe fire sprinkler system into new autoclave area addition.

Extend existing wet pipe fire sprinkler system into new paint spray booth area (total of 2 new booths). Extra hazard group 2 sprinkler spacing limited to sq. Ft. Per sprinkler. Sprinklers provided in exhaust plenum. Separate control valve for each booth. Calculations provided for large booth to justify pipe sizing shown on plans.

Fire

Extend existing wet pipe fire sprinkler system to new paint spray booth. Provide separate control valve for isolation and safety interlock. Paint booth separated from sctf unit submitted under permit 2010-05772.

Milling machine foundation

Footings and steel work for overhead crane and load bearing footings. Includes electrical. G. S. Zone: a. H

New concrete foundation for nitrogen tank relocation. Fencing not included. Seperate fence permit reqd. M-1 zone fiberglass product manufactureing facility. K. A. Zone: k. B. Fire: t. I.

Fire sprinkler system.

New controlled environmental room and second floor office. Construct (1) wood frame 2 story controlled environment" room inside the existing. M-1 zone, add 2nd level w i existing structure.

Interior only, non-bearing removal of masonry & drywall partitions. Remove air handlers & ductwork to be re-installed in new locations under a future permit. Cap off electrical & plumbing & gas piping in selected areas. Remove lighting & ceilings in selected areas. No new work of any kind is under this permit. Cap offs will be done by the subcontractors as who will do the future work. T. B. Zone: m-1 zone - fiberglass product manufacturing facility. K. B.

Electrical work for t. I.

Sump pump plumbing, exhaust fan, lighting, infill conc floor, infill opening with cmu, 8 cmu walls, 26 metal stud walls. G. S. Zone: interior only - no zoning issues. A. M.

New mezzanine, expidited. D. D. Zone: a. M.

Install 3 ea paint booths inside itt main bldg. Fire sprinkler by delta fire. Not part of this permit. Manufacturers installation information attached to plans. Make up air systems by separate permit. G. S. Zone: a. M.

Elec work for new controlled environmental room and second floor office.

Replace 7 evaporative coolers with new. New curbs, duct & roof frame. Existing locations. G. S. Zone: m-1 zone, mech equipment replacement, same locations. A. S.

Ductwork and misc work not classified nor associated with another permit up to 1000. And evap cooler over 65 cfm (7).

1 furnace under 200,0 btu each, 2 ductwork and misc. Work not classified nor associated with another permit contract value over 1000. 00, 1 exhaust fans, etc. And 2 air conditioners between 5 and 6 hp or tons.

Extend existing wet pipe fire sprinkler system to area below new mezzanine in production area.

Extend existing wet pipe fire sprinkler system into new autoclave area addition.

Relocate nitrogen equipent, cooling tower, new platform and pipe rack. Expedited plan review. 10 18 20 revised sheets added to plan sets to reflect job changes. G. S. No zoning issues. A. M.

Add on the existing fire sprinkler monitoring syste for elevator recalc tonew mezzanine

New trim cutting room. Expedited plan review with air condition, lights, outlets, storage, mezz - light. G. S. Zone: interior only - no zoning issues. A. M.

New metal building. Expedited review footing, foundation, floor slab, metal building, power, hvac, fire sprinkler sys. G. S. Zone: a. M.

Extend existing wet pipe fire sprinkler system into new paint spray booth area (total of 2 new booths). Extra hazard group 2 sprinkler spacing limited to sq. Ft. Per sprinkler. Sprinklers provided in exhaust plenum. Separate control valve for each booth. Calculations provided for large booth to justify pipe sizing shown on plans.

Fire

Extend existing wet pipe fire sprinkler system to new paint spray booth. Provide separate control valve for isolation and safety interlock. Paint booth separated from sctf unit submitted under permit 2010-05772.

Dry chemical suppression system for small paint booth

Elec work for new trim cutting room.

Employee function. Fire dept. Approval reqd. A. H.

Furnace cooling unit installation

Install 2 sump pumps andassoc piping

Low voltage fire alarm, connection to paint booth.

Running power and controls for new duct furnaces being installed

Wire auto clave

Changing 9 gas regulators from 1lb gas to 2lb gas.

Fire alarm

Install 6 duct furnaces onto 3 existing evaporative coolers, duct furnaces will be added to evaporative coolers #s 3, 7, & (see permit 100623006 approved plans) g. S. Zone: not hist, m-1-manufacturing building adding coolers. J. U.

Sign

Electrical

Add fire protection to new room

Fire