Hvac installation as per plan.

For the installation of a commercial kitchen hood and alterations to an existing mechanical system in the basement of an existing building. Work to include applicants, registers, diffusers, exhausts, and all supplemental ductwork as shown in approved plans.

Install one ansul r-102 1. 5 gallon wet chemical commercial kitchen fire suppresion system

Fixture installation

Interior alterations to convert existing assembly space to church space relocated from basement area, upgrade bathroom & fisxtures, as per submitted plans.

Reno and addition including 2000amp service,sub panel transformers and feeders,mech sys lines connections,elevator line connection,lighting,rec,electric demo,temp power light,site gate tower per 2008 nec (education facility)install new fa system per nfpa 72

Hvac installation including ductowrk, exhaust fans and mehchanical equipment as per pans. 201 registers diffusers. Separate permit is required for commercial cooking exhaust systems

For the erection of a three (3) story addition on an existing foundation system new footings as per the foundation plan and geotechnical report. For the erection of a three (3) story addition as per approved plans. Proposed structure is to be separated by two (2) hour fire resistance rated - fire wall to create two (2) buildings. Building to be type iiib and iib construction. Entire building to be fully sprinklered. Asbestos abatement required prior to commencement of work. Separate permit required electrical, plumbing, and fire suppression work. Special inspections to performed by engineer on record.

For the complete demolition of building b on the lot. All other buildings on lot to remain.

For the complete demolition of one detached two story structure (building b) for use as a educational facility. All permitted demolition activity to be in accordance with approved site safety demolition plan & such plan to be maintained on site at all times in accordance with code bulletin b-1302r. Any deviation will require an amended building permit. Asbestos abatement required prior to commencing work. All other buildings on lot to remain. 2 17 16 owner was issued permit #659943 4 12 16 request for an extension.

For the erection of one(1) flatwall sign ( above 2nd floor window sill) accessory to existing educational facility.

Install 1" rpz (church)

Reduce 2" meter to 1" meter(school)

For the addition to multiple existing, detached structure (to create one(1) structure on lot); for the erection of third(3rd) story addition of an existing two(2) story structure( ht 45. 75 ft);for the erection of fence at the parameter of lot. For the extention of existing use as an educational facility, with accessory fifty (50) surface parking spaces including with two(2) accessible spaces; for the creation of six(6) bicycle spaces ( should be in an accessible route).( see proviso letter:from tacony civic association dated 3 3 2015)

Ez interior demolition- for the interior demolition of non load-bearing partition walls and ceilings as per attached standard. Deviations from this standard will result in permit revocation and require submission of construction plans.

For the installation of a six (6) inch fire service line with backflow assembly for the installation of a fire suppression system as per nfpa 13. All work shall be done in accordance with approved plans and hydraulic calculations.

Install new recepts and new lighting in the sanctuary and rooftop ac units after demolition of electrical fixtures in existing space as per 2005 nec,(east district)

Interior plumbing construction for a new (3)story addition and alterations to existing (st josephats charter school) to a point 5-0" outside only - note: exterior, 3" backflow prevention containment device and 10" storm sewer 3" water distribution piping are "by others" (separate permits required) - fixture equipment piping must comply with tables p-506, p-811. 2 & p-904. 7 of the philadelphia plumbing code 2004 - water supplies to equipment must be protected against backflow by a method listed in table 608. 1 of the 2009 international plumbing code - the grease traps must be a minimum size of 20gpm 40lb and must be completely automatic or semi-automatic devices to comply with the philadelphia water department industrial waste unit and the philadelphia plumbing code 2004 (manual-type devices requiring the removal of the lid for servicing are prohibited) - unvented water closet branches without additional venting must comply with section p-1105. 1. 1 of the philadelphia plumbing code 2004 an