Install new fire alarm as per nfpa72, install exit lights, egress as per 2005 nec (cc district)

Install of 17 - 100watt owner furnished fixtures to illuminate stained glass windows at night as per 2005 nec (cc district)

(2) 20amp, 110v, and (1) 30amp, 220v temporary branch circuits from existing 2 amp, 30- circuit breaker panel from march 27th to april 30th for church function. Weatherproof receptacles and covers.... In accordance with 2008 nec

Install (1) 3-compartment sink, (1) prep sink, (1) hand sink, (1) dishwasher, (1) ice bin, (4) floor sinks, (1) trench drain, (2) floor drains

New kitchen installation, install second 200a service off of existing 2-phase service. Demo old service,add kitchen hood ansul system to existing fire alarm system as per 2008 nec,nfpa-72

New lights, 100amp single phase feeder for elevator, demolition of old lgts, new recepts & switches, new 100amp safety switch, add fire alarm to existing system as per nec 2008 & nfpa 72 (church)

For the installation of mechanical equipment and piping as shown per approved plans. All work to be done per approved plans, if field conditions vary contact design engineer prior to the start of any work. Separate permits required for electrical and plumbing work.

Installation of commercial kitchen exhaust hoods and ductwork system. Exterior duct & louver to be painted brick red, matte finish separate commercial cooking fire suppression permit required for type 1 hood .

Ez permit re-roofing- for the installation of new roof coverings on exiting roofs as per attached standard. Deviations from this standard will result in permit revocation and require submission of construction plans.

Installation of a commercial cooking exhaust and make-up air system. Separate commercial cooking fire suppression permit required for type 1 hood.

Installation of kitchen hood fire suppression system. Refer to ap#344183 for kitchen hood permit.

Complete new fire alarm system as per nec 2008 & nfpa 72 (church)

442-ckts panel, 68-recpts, 37-sw, 104-lgt outlets, 15-emer battery lgts, 5-remote battery wp dual egress lts 12-battery exit signs as per nec 2008 (church)

For the re-roofing of 6 sf flat roof section with epdm roof to conform to ez permit standards. No change in building height, area, floor area, bulk, use, or signage.

Interior exterior alterations and structural work to include accessiblity upgrades for the installation elevator and shaft for lower level and ground level floors, foundation work, interior demo and new slab work, exterior entrance modifications, lowering lobby floor area, new floor reconfiguration, finishes, as per submitted plans. Underpinning of existing interior foundation requires special inspection by engineer. No change in use or occupancy existing pre code use. Additional permits req: electrical, hvac . Per phc : existing granite slab step will be lowered flush with sidewalk.