Relocate outlets, switches, lighting, install new ones, same for fire

For the installation of two (2) non-illuminated flat-wall awning signs and two (2) statically illuminated flat-wall signs. Size and location as shown in application. For use as signs accessory to a previously approved take-out restaurant in 1st floor corner space (broad & lehigh) in the same building as other uses as previously approved.

Install new receptacles, switches and lighting as per 2008 nec (north district)

Ductwork layout and grills,registers diffusers as per plans.

Relocate 85 sprinkler heads (2nd and 3rd floors)

Wire and install new transformer and wire new fire pump as per 2008 nec

Remount 12 smoke detectors, 15 horn strobes no new wiring as per nfpa 72

Supply & install 2 voice and data cat 5e lines & jacks as per 2008 nec

Ductwork, vav & grd per plans to 3rd flr. In office bldg.

Rough-in plumbing from existing to add a water closet, lav sink and floor drain

Install additional fixtures and outlets as per 2008 nec (north dist)

Fit-out of former donut shop for use as a subway resturant, including new floor wall and ceiling finishes, new counters, seating, and trim.

Relocation of existing countertop receptacles, lighting fixtures, install approx-5 new appliance ckts, approx 15-2x2 troffer lights, using existing service (store)

Supply,install 212 voice and data cat 5 e jacks as per 2008 nec

Install (5) receptacles, 2 new switches, 2 exit lights, emergency light combos, as per 2008 nec (north dist)

For interior demolition & for prescriptive alterations w. No change of occupancy classification to include erection of partition walls for office, conference meeting, toilet room, & corridor spaces to create medical office space within an existing mixed-use office building; work area to be fully sprinklered. Separate permit required for mechanical, electrical, plumbing, & fire suppression work.

Rough-in from existing to install 4- water closets, 5- lavatories, urinal and kitchen sink

Remove existing epdm roof membrane and insulation and install new insulation and epdm membrane to match existing roof system(commercial)

Fast form building permit

Ductwork modification for tenant fit-out

Erection of 2 wall signs and 2 awnings as per plans

Replace existing 15kv load break switches with new peco approved 15kv load break switch as per 2008 nec

Inst fiber optic cables on exist cell site rem & repl some exist antennas inst 3 lines of outdoor rated h&s mle hybrid fc 2-125 1-150from antennas to purcell telco cabinet on exist rooftop equip platform as per nec 2008 site 1ph1111b

Rooftop - site 1ph1111 (electrical alterations) - upgrade wiring to #6 and breaker from 50amp to 60amp

Taking old 7 fixtures out and installing new fixtures, running new water line for front counter cold water only

Install 2 amp service as per 2005 nec (north dist)

1 o door telco cab,remove 9 ex anten replace w 9 new anten,6 lns of 1 5 8"commscope coax run from back of the new anten to telco cab,2 line runs at 120,2 at 160 2 at 115,1 gps anten mounted to ex equip pform-1 ln of 1 2" coax long per 2005 nec(north dist)

Remove stone via vac. Mechanically attach 1. 5" iso over existing roof system adhere . 0 epdm roof system. Reroof

9 fixtures with piping for bathrooms on 2nd floor

Relocate heads in new tenant space