For the removal of the previously approved roof sign. No change in previously approved uses. No change in height or area of building.

Interior alterations, to include structural work, as per plans. Separate mechanical, electrical, plumbing and fire suppression permits required.

Refacing of existing externally illum. Single face roof-top sign as per plans. Work must be performed by licensed sign contractor

Relocate 79 existing sprinkler heads (commercial)

For the removal of the existing roof sign per approved plans and engineers report. Street and sidewalk at 25th street to be protected by a covered walkway and street closure. Separate permit required from streets department for closure separate permit required for covered walkway.

Remove and replace kitchen sink and mop receptor, reconnect to existing plumbing rough-in

Install light fixtures,switches,receptacles,communication outlet box. Install 125amp 208 volt panel and feeder per 2008 nec (apt bldg)replace and relocate fire alarm device per nfpa 72

For the replacement installation of registers, diffusers and mechanical appliances with associated ductwork on the ground floor of an existing building. Appliances to be installed in accordance with manufacturers specifications. All work to be done per approved plans. If field conditions vary contact design engineer prior to the start of any work. Separate permits required for all other work.

Erect sidewalk shelter platform as a "catch" for pedestrian protection as per engineered plans. To partially comply unsafe violations. Additional permits required for full abatement of unsafe condition.

Relocate (10) existing sprinkler heads in order to accommodae tenant layouts as per nfpa no. 13 and all local codes.

For exterior brick and concrete repairs to an existing residential building as per approved plans. Pedestrian protection methods approved under permit #718279.