Installation of brick veneer on 1st floor exterior wall

Install 60k btu 92% gas fire furnace with a 2. 5 ton a c to the existing duct on 1st fl

Infill existing exterior wall door opening with cmu; create new door opening and install pre-cast lintels (entrance to be fully accessible); interior alterations including concrete platform on grade, accessible bathroom, service counter and bench per plans to create self-service laundromat, c o included for change in occupancy with no change in occupancy classification. Separate permits required for all mechanical, electrical and plumbing work.

Interior plumbing alterations on the 1st floor to create a self-service laundramat - note: separate permit required for fuel gas, 1-1 2" backflow prevention containment device and 1-1 2" water distribution piping - the lint interceptor must comply with the minimum requirements of the philadelphia water department industrial waste unit - the installation will comply with the approved plans and the philadelphia plumbing code 2004

Upgrading 200a service to 300amp service, install 100a sub panel & 1-2 sub panel, wire laundromat, 13-washer, 7-gas dryer, 12-lights, 8-outlets & 4-switches as per nec 2008 south district

Install 1 - 1 2" water distribution pipe - pa1# 2015-2593474 - "self-certifications are no longer permitted" - "all excavations and plumbing trenches in excess of 5 feet in depth must have approved shoring in place at the time of inspection"

Install two 2 ton heat pumps systems with related duct work,one system will be on 2nd fl, one system in the basement