Rough-in and installation of hot and cold water supply lines and sanitary waste for five (5) lab sinks for science classroom

To remove and replace lighting fixtures and add receptacles in 6 classrooms and 3 new power panels, add telecom outlets to 6 existing classrooms as per 2008 nec (south dist)

For the installation of one (1) 10,0 gallon (fuel oil tank) below ground storage tank. All work to be in accordance with pennsylvania d. E. P in accordance with state regulations, all applicable codes, nfpa 30, and nfpa 31.

Installation of floor drains, trap primers & domestic hot water heater per the approved plans - note: sump pumps & fuel gas piping requires a separate permit - work will be in compliance with the philadelphia plumbing code 2004

Separate permit required from pennsylvania department of labor and industry for installation of boilers see asbestos report installation of hydronic piping, pumps and miscellaneous mechanical equipment for steam heating system per plans. Approval also includes interior demolition at mechanical room, installation of new concrete slab, housekeeping pads, metal stair, exterior door landing and louvers per plans. Separate permits required for all electrical, plumbing, fuel gas work and underground oil storage tank.

Power wiring to boilers, pumps, lights & receptacles as per nec 2008 south district

Level i alterations to include removal of existing roofing material down to concrete roof deck, roof deck will remain, installation of new roofing membrane and masonry work as per approved plans and specs.