Power back rehab bistro. Install (4) amp 1 volt dedicated receptacles cir and (1) amp 208 volt. 1 phase dedicated circuit in each of the bistro located on the 2nd & 3rd floor per 2008 nec (health care)

Construction of a masonry trash room on ground floor of an existing structure and a canopy as per approved plans.

Disconnect electric from existing hydraulic elevator equip. Install new 150a 3p 208v short trip breaker on existing 200a feeder. Install wiring between short trip brk & new 20a elev control panel . Replace light elev pit & install gfic recep. Install 120v emer cir, safety sw in mach rm for car lgt. Connect short trip brk into fa control module. Relocate 2-60a safety sw. Install & gfic recep machine as per 2008 nec

Install enclosure at lobby entrance under existing building above as per plans.

Relocating existing sprinkler heads from a wet pipe system on the 4th, 5th and penthouse levels to accomodate new ceiling and floor plan for nursing home. In conjunction with renovations permit ap351936

Add 1 smoke detector per nfpa72, wiring of 1 electric heater, 4 lights, 1 emergency light, 1 exhaust fan, 1 switch and 1 recept as per 2008 nec (south district)

Hvac. See ap#351936 for plans

Remove existing fixtures and replace new rewire and add panels and circuits for hvac electrical circuits, relocate existing smoke detectors & add 2 new smoke detectors as per 2008 nec

Rough in plumbing from exsiting to install 63 water closet 65 lavs 58 showers 76 sinks 2 bath tub 2 mop sinks 4 floor drains 4washer machine boxes 1 drinking fountain

Roof recovering (epdm).

Interior renovations to existing geriatric care center. No change in occupancy.

For the installation of mechanical appliances in trash room for an existing health facility. All work to be done per approved plans. If field conditions vary contact design professional prior to the start of any work. Separate permits required for all other work.

For the installation of three sprinkler heads in a trash enclsoure on the first floor level, proposed line to be connected to existing system. Fire supression system to be installed in accordance with nfpa 13. Separate permits required for all other work.