Installation of new ul kitchen hood per plan.

Run electric power to the septa bus shelter on the corner from the closest light pole and protect the circuit feeding the bus shelter with a 20amp fuse as per 2008 nec (cc district)

Installing two new panels from new switch gear. Switch gear is being installed by another contractor. Fire alarm is being install by another contractor. Light fixtures are supplied by owner. Installing conduit for security, cctv, intercom, voice data wire. Installing new branch circuits. (cc dist).

Fixture replacement

Installation of (3) heat pumps with associated ductwork for lobby

Relocate existing sprinkler heads to accomodate new partition layouts. Heads will be raised or lowered to accomodate new ceiling height. No changes to exterior and no work alterations to windows & doors.

Replace 2 curb traps

Install new wet sprinkler system, new backflow

Replace existing 1 recepts with new. Add line voltage smoke dets (12), all work to be done in existing apts (only). New panel will be installed by a different contractor. Building fa work done by other contr. Per nec 2005.(cc dist)

Install 15kv service entrance switch, metering section, 1500kva 13,200v 208-120v transformer & 12 100a 208-120v 3-phase 4 wire hvac panels.

Wire the 1 bed room apartment as per drawing as per 2008 nec

Extend existing fire alarm system into new tenant space.

Replacement of emergency generator & transfer switch. Add new panel, no fire alarm as per 2005 nec (cc dist)

Toilet and basin installation

Remove misc. Valves, pipes and water storage tank remaining from abandoned steam heating system in basement area.

Install 1 new manual wet class i standpipe in interior stairway. Interconnect both standpipes and fdc. Remove class ii standpipe system and provided proper signage for fire dept. Connection to comply with the board of safety and fire prevention board provisos, variance #2011-010.

1 sewer ejector pumps, 6 floor drains 1-3 compartment sink 1 mop sink 2 hand sinks 2 bar sinks 1 prep sink and 2 kitchen sinks (commercial)

Install new 200amp 3 phase panel, install lights & power as per 2008 nec (restaurant bar)

Relocate sprinkler heads in order to accomodate tenant wall and ceiling layout as per all nfpa no. 13 and local codes (no change to exterior, no work on windows and doors per hist. Comm.)

Replace curt trap & lateral (apt bldg rest) pa20132971491

5 square feet, interior demolition of non load bearing walls and ceilings only. No other work allowed under this permit. Separate permits required for renovation. No changes to exterior as per philadelphia historical commission. No structural changes. Must maintain all code required fire rating on wall and floor ceiling assemblies. Three sets of plans drawn to professional quality are to be submitted for review and approval by the department before work on renovation starts.

Installation of a commercial cooking fire extinguishing system. No work outside of building.

Alterations to existing hotel room. New partitions ,ceiling doors.

Interior alterations as per plans, structural slab modifications, lobby and vacant space reconfiguration, new ada bathroom. Vacant space requires use registration permit, co and fit out permits prior to occupancy.

New fire alarm system, basement thru 12th floor and roof levels. (center city dist)

House drain in the basement and waste line for the kitchen sink replacement - install a vanity, kitchen sink and dishwasher

Branch circuit wiring for: 2 dupl recepts, lt sws, lts, elect ranges, elect heaters, remote condensors. From existing electrical panels.(cc distr). No fire on this permit

Installation of shelter platform

Relocation of (19) sprinkler heads to conform to floor and ceiling layout on 1st floor.

Install hvac system to include ductwork as per plans

Install cat 5e tele data cables & remove relocate 4 cctv cables & cameras. Install speaker cabling & speakers at 4 locations.

Install 4 amp panel, receptacles, lights and wier kitchen equipment as per 2008 nec (cc dist)

Install branch circuits in existing apts new recepts, switch and lilght fixtures, install 120v interconnected smoke detectors. 125amp panel and building fire alarm is to done by a different electrical contractor. (center city district)

Install two 120v 20amp circuits from existing panel to feed two fire shutter doors and two control switches all wiring to be 12 2 mc type cable as per nec 2008 cc district

Install (12) amp 1 volt receptacles, (14) light fixtures, (3) switches, as per 2005 nec (cc dist)

Replace trims and bulbs in 28 recess lights - replace 2 led strip lights - install new recess lights and house trims - relocate 7 outlets disconnect and reconnect 6 display cabinets - remove 2 outlets from under front windpow - inspall 2 new outlets and circuits in accordance with nec 2008 (central district)

Alterations to storefront as per plans. Signage approval is not part of this permit; separate permits required.

Interior demolition of first floor merchantile jewelry store

Interior alterations only, as per plans. Work to be performed at existing stroefront will require separate city planning and philadelphia historical commission approval as well as a separate permit for the same.

Install cables for 12 speaker sound system 5 point of sale outlets 5,4 fire alarm install 1 new booster panel,2 pull station,5 speakers strobes,1 strobe only and 4 monitors modules as per 2008 nec,nfpa-72

Installing kitchen sink with garbage disposal and dishwasher no new piping

For alterations to an existing fire suppression system to include the installation of a new fire pump and conversion of exisiting standpipes to manual wet standipes, in accordance with nfpa 2007, standards 13 and 14.

Installation of hvac system and accessory mechanicals including new ahus, duct work diffusers, fans, vents, kitchen hood and separate exhaust duct work as per submitted plans and specifications. Phc : only exterior work occurs with the venting on the moravian street facade as per attached drawings.

Rough in plumbing from existing to install 1 powder room, floor drains, floor sinks, sink including prep

Relocate exisitng sprinkler heads. No installation of new feed main heads or new cross mains.

New service entrance equipment 208 1 v 3ph-4w, 40 amp, (2) 16 a vertical bus duct risers, (12) new 208 1 v 3ph-4w, 4 a distribution panels. Miscellaneous lights and recepts. (cc dist) no fire alarm.

Installing all new branch line voltage wiring in exisitng apartents. Installing interconnected line woltage smoke detectors, , each apartment has an existing annunciator from building frie alarm panel. Panels are being installed by another contractor.

Rough wiring for 8 floors, 56 units only, final termination and devices by others. 3 cat5, 128 coax, l0ng 1 running cabling only. (center city district)

Using existing 3 phase 13. 2 kv peco svs. Install new 4000a buss duct distribution system throughout include:new dist. Panels each fl. Re-wiring of common hallways. New f. A system thoughout. New tele cable tv in each unit per nec 2005

Installation of duplex sewage ejector for one toilet, basin and floor drain in basement below main drain elevation.

Steel work documented on drawings also injection of cement grouting for waterproofing purposes alongside the basement foundation wall on east side of property in private drive. Steel work is all alongside the building as per plans. No exterior work.

Install 225amp single phase feeder and panel from existing distribution panel to tenant space, 4 light fixtures in basement storage area as per 2005 nec, no fire alarm (cc district)

Feed new fire pump per 2008 nec (hotel)

Replace 3 ton heat pump with same. No ductwork

Replace fixtures

Furnish and install ductwork diffusers, air devices, exhaust fan, ductless split system wall mounted heat pump for new layout

New generator exhaust duct

(for condensate), with trap primer

Relocate (22) existing sprinkler heads.

Install light fixture, devices, tie branch circuits into existing 208v 3 phase panel board, conduit and pull strings for tele data as per 2005 nec retail space (cc district)