Hotwork: welding cuttinf soldering torch work- to include gas and electric welding expires 03 07 2014

01 17 2013 errect one (1) assembly use tent auto show

Fire alarm new installation: install fm 2 system in rooms, 184,185,186,168,302 and 308 as per nfpa-72 (cc dist)

Installing outlets using existing circuits to accommodate new appliance arrangement, replacing existing lights with led lights, installing new oven outlet only as per 2008 nec (tasting room in convention ctr) no additional wiring

Install lighting, receptacles, switching & wiremold per plans.

Install laterals (3-24",2-18",2-16",2-10",3-8")

Interior alterations as per plans

Install 1st floor north east underground fire mains as per plans and two 10" ames colt 2 double check valve backflow assembly as per pwd approval. Separate permit and hydraulic calculations required for sprinkler system installation.

Install tele communications and new fire alarm system as per nfpa-72 (cc district)

Installation of powerk lighti8ng, lighting protecton, substations and generators as per 2005 nec (cc district)

Hotwork: welding cuttinf soldering torch work- to include gas and electric welding as part of a trade show- permit expires 11 03 2011

1 25 2012 for the installation of one (1) x 35 tent for exhibit at shaffer sport.

Install commcercial cooking fire extinguishing system

Replacement of three (3) existing roof top cooling towers with three (3) new cooling towers with all associated work as per plans. Work shall include include alterations to the existing steel platform (supporting structure of cooling structure). See attached structural design criteria form & special inspection form all work shall be in accordance with approved plans. Separate permits required for plumbing, electrical, and fire suppression permits.

Demo pip & wire from existing motors 2- motors per cooling tower total of 6, install new conduit & wire new motors on new cooling towers 6-motors current & voltage will remain as per nec 2008 (comm)

Removal of one existing cabinet and installation of new cabinet per 2008 nec (commercial cell site)

Relocate 3 sprinkler heads (ste #bc-1)

1 floor sink

Renovation to existing stand, install receptacles, reuse existing circuits from demolition, no anticapated change in load as per 2008 nec

Installing 7 pendant lights,6 ceiling fans,18 convenience outlets & 2 amp,3 phase 120 200v panel for this load & future work (convention center)(cc district)

Interior demo. Removal of int finishes and millwork-cafe bar 10 square feet, interior demolition of non load bearing walls and ceilings only. No other work allowed under this permit. No structural changes. Must maintain all code required fire rating on wall and floor ceiling assemblies. Three sets of plans drawn to professional quality are to be submitted for review and approval by the department before work on renovation starts.

7 commercial kitchen fire suppression systems.

Install (2) floor drains, (1) indirect waste,3" line vent through roof

Replace existing fire alarm devices with new siemens deviced, replace main fire alarm panels as per nfpa-72 (cc dist)

Running new 2 emt from telephone room to at & t site as per 2008 nec (cc dist)

Install 1-208v twist lock outlet. Disconnect and reconnect power pole after new countertop installation.... In accordance with 2005 nec

Replace section of 12" lateral from sewer main to house trap (used existing hole in sewer)- pa one call # 2013-1203223- per rick mitchell: was told by water dept that a pwd permit not reqd as street was already open via cave in- ok to issue per b gledhill

2 control panels,14 terminal panels,38 cluster speaker, 142 a v fire devices per 2008 nec & nfpa 72(convention center)

09 17 2015 erect seven (7) tents, ( x 20) each, in unison along 1325 arch street to be used for standing and exhibits. Total of 14 square feet combined. For the duration of 9 22 2015 thru 9 27 2015 for the world meeting of families event.

Install 114 2x4 lay-in light fixtures, change existing receptacles to gfci protected receptacles as pre 2008 nec (cc district)

Replace old dry pendent in freezer and replace old heads in kitchen with new heads in same location. Heads

02 06 2013 errect one (1) assembly use tent auto show

Provide a total of ten (10) amp, 120v duplex receptacles in a temporary wall for construction of the expansion project. Provide a total 2 exit signs and provide six (6) lighting fixtures (cc dist)

Diffuser relocation.

Remove and relocate existing receptacles, switches and lighting for temporary office relocation. No new panel work.

Install data drops and 18 voice drops

Fast form building permit

Interior demo to include mep and fp systems.

Sidewalk shed shelter platform scaffold

Concrete repairs to loading dock as part of existing convention center.

Replace existing lighting controls & lighting fixtures for conference rooms as per nec 2008 (convention center) cc district

Install 7-new roof drains and connecting to the existing rain water conductor piping. No addtl sf of roof was added to the existing rwc piping

Installing automatic clean agent fire suppression system.

Relocating existing wires and circuits and install 2-280v circuits (new) per 2008 nec (convention center)

Replacement only: sink

Install 2-30amp, 208v outlets & 3-120v outlet, 1-switch, 2-track lights, no addl wiring as per nec 2008 (convention center)

Install appliance outlets & tv & pos data drops, approx outlet combined as per nec 2008 (convention center)

Installation of 125kw generator for temporary power for sound and for an underwriters inspection of magnificent day on 11 8-11 9 as per 2008 nec (cc district)

Excavate to examine 10" curb trap and 8" vent to determine reading terminal convention center