Interior and exterior alterations (level ii) to 1st floor tenant space (137-39 n 11th st). Alterations to include the erection of non-bearing partitions, accessibility upgrades, casework and finishes. Change of occupancy to hair salon. Separate permit required for plumbing, mechanical and electrical work.

Renew all fixtures - 3 indirect waste, 5-sink (restaurant)

Outdoor camera system only as per 2008 nec (restaurant) no other work to be done under this permit

Replace fluorescent lights with recessed lights,replace 5 switches an d replace 5 switches and replace receptacles and add 5 receptacles per 2008 nec (restaurant)

Permit for repairs to comply violation, case # 180551. Work to be completed as per attached plans stamped by registered p. E.

Repair of brick columns

For level ii alterations to combine existing tenant spaces for the use of an sit down restaurant. Tenant space to be fully sprinklered. All work to be done per approved plans. Separate permits required for mechanical, electrical, plumbing and fire supression work. Separate certificate of occupancy required.

Repair of existing concrete roof deck for garage as per plan, copies of all inspection reports to be given to l&i inspector.

Wire a hair salon in a vacancy office space as per plan

For the installtion of one flat wall sign as per plan

Ez permit ductwork & warm-air appliances-to modify existing ductwork for an existing 5 ton 2000cfm hvac system within the first floor tenant and relocation of 2 diffusers of totoal 6. No chimney required. The system and ductwork to remain self contained within this tenant space no vertical horizontal penetrations for the installation of new ductwork, registers grilles diffusers, and warm-air appliances as per attached standard. Deviations from this standard will result in permit revocation and require submission of construction plans.

To install fixture and pipes on the 1st floor 2 shampoo backwash sinks 1 washer,1 water closet and lav (hair salon)

Replacement of fire suppression system for bakery.

Reconfigure receptacles to fit new lay-out only.

Replacment hood in existing duct work and fans.

Remove and replace steel angle and brick masonry