Demolish ca. 2 sq. Ft of concrete ground level slab to locate sewer pipe in preparation for long form

Install 30kva 2 to 480v step up transformer and circuit panel for power distribution. (new machine)

Replace lighting with energy efficient fixtures at brayton wilson cole corp.

New partition walls new bathrooms new electrical service new heating system new hvac reroof metal shed roof update fire alarm system insulate walls and ceilings.

Rough and finish plumbing

New wiring for four offices and service work

Tenant fit out in commercial space. Adding hs and smoke detector devices in 1st floor space.

Wiring plugs for new partition walls in office space.

Construct 3 small offices and a closet within existing shell. No structural work.

4 gas lines to 4 condensing boilers

Install telecom wiring for phone system for tenant (merrymaidfs) moving in december 2012.

This application is to amend permit alt 123526 by filing new drawings

Erect ca. Lin. Feet of metal framed walls to create three offices. All other work done under previous alt123526.

Amend permit alt 123526 to include stamped hvac drawings and stamped lighting layout plan and interior lighting compliance certificate. All work done under alt 123526.

Wiring for low voltage fire alarm system

Wiring for plugs and switches on new partion wall

Install 8 outlets

Install wiring for cat 5 jacks

Installation of burglar system.

Installation for burglar alarm sysstem at 98 magazine street

Perimeter walls: repair spalled concrete.

Install fire sprinkler system for existing building as per plans. Amending permit# alt123526

Replace lighting with energy efficient fixtures at boston design corp. Common areas 617-541-4214.

Adding new devices for fire alarm due to tenant fit out and sprinkler system being added to complete building

Adding fire alarm pull stations smoke detectors and horn/strobes to an existing system.

Build out 6 offices in existing shell. Install new carpet and install 7 half wall partitions per plan.

Installation of;two new awnings one on the east side &; one on the west side of the building per attached bra approveddrawings. Awnings do not overhang any public way.

Pour new concrete slab over exisitng install new ada bath new rear stairs new storefront entry. Frame and insulate all exterior walls. New hvac ductwork. New suspended ceiling. New gwb on all exterior walls. No sprinkler work. No fire alarm work. New storefront at entry and new 2 hr wall at lobby. Remove two overhead doors.

Go over existing siding and installing new metal siding

Install new sprinkler system in accordance with nfpa 13 and isd approved plans

Remove existing coal tar pitch down to the structural metal roof decking. Mechanically fasten a new layer of 1. 5" polyiso install johns manville dynagrip base ply over iso with self adhered adhesive install johns manville dynaweld cap sheet over base ply (heat fused). Fabricate and install . 032 aluminum gravel stop

Insatll cat 6e for 25 telecom phones and computers

Remove 8 isting windows and replace new windows to match the rest of the building.

Installation in accordance with requirements of 7 cmr &; nfpa 13

Install amd furnish switches recptcales and data for new office rooms and cubilce furniture.

Remove existing fire alarm devices temporarily while walls being done and then reconnecting fire alarm devices. Temporary removal of 3 horn/strobes 2 strobe only and 2 pull stations. Removal for 3 days max.

Legal occupancy:;offices &; manufacturing temporary coo for the base building - 1st floor only.; adding 4 additional office space on the 1st floor to the tco. Temporary certificate-expires -2/3/2015-pending completion of permit alt349026 ssued: 5/5/14 alt4100 issued: 10/31/14 alt123526 issued: 6/18/12 alt182556 issued: 10/9/12 sf108978 issued: 12/6/11 alt224973 issued: 1/7/14 alt201131 issued: 12/17/12 a278763 issued 9/30/2013 a173197 issued 12/17/2012 ;

Adding and relocating devices for a tenant fit out in unit #6 for the fire alarm system.

Offices warehouse;&; manufacturing certificate of occpancy for offices warehouse manufacturing; alt349026 ssued: 5/5/14 alt4100 issued: 10/31/14 alt123526 issued: 6/18/12 alt182556 issued: 10/9/12 sf108978 issued: 12/6/11 alt224973 issued: 1/7/14 alt201131 issued: 12/17/12 a278763 issued 9/30/2013 a173197 issued 12/17/2012 sf427466 issued; 11/18/14 ;

Remove and reconnect existing fire alarm devices due to walls being insulated and sheetrock being installed.

First floor new construction

Install surveillance system.

Wiring and install of plugs switching and lighting

Renovation of 4 0 square feet of commercial office space to include 7 offices 2 conference rooms new electrical and data wiring and rework to existing hvac. New furnishings to include new carpet cubicles gwb and paint.

Change occupancy to;eliminate laundry use and clarify occupancy occupancy to now be;offices &; manufacturing renovation and plans under alt349026. No work to be conducted under the terms and condition of this permit.

Remove and replace existing concrete floor